User's Manual

ManualsBrandsClimax Technology ManualsElectronicsWireless Outdoor Bell Box

BX-32ZW Outdoor Bellbox

Introduction

BX-32ZW is a Z-Wave Outdoor Bellbox. It is capable of raising alarm upon receiving alarm signal from

the Z-Wave network when an alarm is activated. During the alarm, the Bellbox will sound alarm with its

built-in siren and also flash the strobe light to attract attention.

The Bellbox is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network.

Z-Wave is a wireless communication protocol that uses a low-power RF radio. By taking advantage of

the Z-Wave mesh network, commands can be transmitted to their destination via intermediary “listening”

Z-Wave products.

Parts Identification

1. Tamper Switch

The Tamper switch will be activated when the Bellbox is removed from mounted surface, or it cover

opened.

2. Battery Compartment

The Bellbox is powered by two 1.5V D-Cell alkaline battery.

3. Battery Switch

The battery switch is used when battery is installed in the Outdoor Bellbox. To power on/off the

Outdoor Bellbox, switch the ON/OFF button.

4. Mounting Holes x 3

5. Function Button

- Press the button 3 times within 1.5 seconds to send a learn code.

- Press and hold the button for 10 seconds, Refer to Removing Device (Exclusion) for details.

6. LED 3 & 2 & 1 (From left to right)

Summary of content (5 pages)

PAGE 1
BX-32ZW Outdoor Bellbox Introduction BX-32ZW is a Z-Wave Outdoor Bellbox. It is capable of raising alarm upon receiving alarm signal from the Z-Wave network when an alarm is activated. During the alarm, the Bellbox will sound alarm with its built-in siren and also flash the strobe light to attract attention. The Bellbox is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Z-Wave is a wireless communication protocol that uses a low-power RF radio.
PAGE 2
Features z 1. LED Strobe Light The strobe light includes 3 LEDs (From right to left: LED 3-> LED 2->LED 1). Refer to below table for LED and siren beep for status indication.
PAGE 3
z Removing Device (Exclusion) The Bellbox must be removed from existing Z-Wave network before being included into another. There are two methods available to exclude a device. Exclusion Mode z Put the Z-Wave gateway or control panel into Exclusion mode (please refer to the Z-Wave gateway or control panel manual). z Within 1.5 seconds, press the Function Button 3 times and the Bellbox will be removed from the Z-Wave network.
PAGE 4
) The tamper switch is secured with a button at the back of the base. When the siren is pulled off from the wall, button will be released, the alarm will be activated. Ensure the button is fully depressed when the siren is mounted. If there is a gap, pack with a suitable spacing material. 7. Replace the Top cover by hooking the top of the Top cover onto the top of the base. Push the bottom of the Top cover onto the base and tighten the bottom screw using a Philips screwdriver. 8.
PAGE 5
receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules.