User's Manual

Acoustic Glass Break Detector (ACGS-23)

The Glass Break Detector detects the high frequency sound emitted by glass breakage and transmits signal

to notify the alarm system control panel when it is triggered.

Parts Identification

1. Green LED Indicator (Inside)

2. Red Indicator (Inside)

3. Microphone

4. Dip Switch

5. Battery Compartment

6. Learn / Test Button

-Press the button once to send a learn code.

7. Tamper Switch

-The tamper switch is compressed against the back cover and protects the Detector from cover

opening or removal from mounted location

8. Breakaway Area

The Breakaway Area has 2 knockouts where plastic is thinner for screw mounting. When the Detector

is forcibly removed from mounting location, the Break Away area will detach and allow tamper switch to

be activated.

LED Indicator

z The LED indicators are inside the front cover and only visible when activated.

z Red LED: The Red LED activates when:

¾ Tamper Switch is activated.

¾ Learn/Test button is pressed.

¾ Glass break detected under Test Mode, Low Battery or Tamper open condition

(The Red LED does not light up when glass break is detected during normal operation)

z Green LED

The Green LED activates when glass break is detected under Test mode.

Getting Started

1 Insert the battery to power on the device.

2 Put the Control Panel into learning mode, refer to panel manual for detail.

3 Press the Learn/Test button once to transmit learn code to panel.

4 Refer to panel manual to complete learning process.

5 Refer to panel manual to complete the learning process.

z Sensitivity Adjustment

The Glass Break Detector sensitivity can be adjusted using the two dip switches. Adjust the sensitivity

to change detector range.

Sensitivity Dip Switch 1 Dip Switch 2 Detection Range

PAGE 1
Acoustic Glass Break Detector (ACGS-23) The Glass Break Detector detects the high frequency sound emitted by glass breakage and transmits signal to notify the alarm system control panel when it is triggered. z Parts Identification 1. Green LED Indicator (Inside) 2. Red Indicator (Inside) 3. Microphone 4. Dip Switch 5. Battery Compartment 6. Learn / Test Button -Press the button once to send a learn code. 7.
PAGE 2
z Maximum OFF OFF 8m Medium OFF ON 5m Low ON OFF 3m Minimum ON ON 1.5m Test Mode The Test mode is used to help check the Glass Break Detector’s detection distance. When the Learn/Test button is pressed, the Glass Break Detector will enter Test mode for 5 minutes. Pressing the button again during the 5-minute period will reset test mode time to 5 minutes. During Test mode, both Red and Green LEDs will light up when glass break is detected.
PAGE 3
Adhesive Tape Mounting When using provided double side adhesive tape, make sure to install the detector on flat surface. Do not I install on uneven surface or location with cracking paints. 1 Clean both the detector back cover and mounting location with suitable degreaser. 2 Apply the double side adhesive tape to back cover of detector, then apply to mounting location. ) When mounting with double side adhesive tape, the tamper protection for mounting location removal will be disabled.