User's Manual

1
PIR Motion Sensor Camera
VST-862P-F1
Introduction
VST-862P-F1 is a passive infrared (PIR) motion sensor camera. It is capable of sending wireless signals and captured
images (picture quality of up to 640 x 480 pixels) to the Control Panel upon movement detection.
The PIR Camera is designed to give a typical detection range of 12 meters when mounted at 2 meters above ground. It
has a pet-immune range of 7 meters and will not trigger false alarm from your household pets within this distance.
The PIR Camera consists of a two-part design made up of a cover and a base. The cover contains all the electronics and
optics and the base provides a means of fixing. The base has knockouts to allow mounting on either a flat surface or in a
corner situation with a triangular bracket for corner mounting.
Parts Identification
1. Flash LED
The Flash LED delivers sufficient light for image capture under low lighting
condition.
2. Blue LED/Function Button
Blue LED:
(Please refer to LED Indicator description below for details)
Function Button Usage:
- Press and hold the button for 3 seconds to send a learn code, release when Blue
LED light on.
- Press the button once to enter test mode for 3 minutes.
3. IR Sensor
4. PIR Camera Lens
5. Battery Compartment Cover
6. Tamper Switch
7. Battery Compartment
8. Sensitivity Adjustment Jumper Switch (JP3)
- Jumper On: the PIR’s sensitivity level is set to High.
- Jumper Off: the PIR’s sensitivity level is set to Normal. (Factory Default)
9. Sleep Timer Jumper Switch (JP2)
- Jumper On: After movement detection, the PIR Camera does not enter sleep mode and
will transmit detection signal again immediately if triggered (Factory Default).
- Jumper Off: PIR Camera has a “sleep time” of approximately 1 minute after motion
detection to conserve power.
Features
 LED Indicator
In Normal operation mode, the Blue LED will not light except in the following situations:
 When the PIR Camera is in low battery condition, every time it transmits a detected movement, the Blue LED will
flash for 2 seconds.
 When the cover is opened and the tamper switch is violated, the Blue LED will flash for 2 seconds, to indicate it is
transmitting “Tamper” signal.
 When the Tamper condition persists, every time it transmits a detected movement, the Blue LED will flash for 2
seconds.
 When PIR Camera enters Test Mode, the Blue LED will flash for 1 second. During Test mode, the Blue LED will
Jumper On
The jumper link is inserted
connecting the two pins.
Jumper Of
f
if the jumper link is removed
or “parked” on one pin.
Jumper On
The jumper link is inserted
connecting the two pins.
Jumper Of
f
if the jumper link is removed
or “parked” on one pin.