#2130 – PATIENT BOX IDENTIFY THE PARTS: Front view Power LED HOLD HOLD/ RESET Low battery POWER ON/OFF Nurse call jack Power Bed/ Bed/ floor floor Jack sensorsensor Internal view SW2 Buzzer Battery
#2131 – BELL BOX IDENTIFY THE PARTS: Front view Gree LED Orange LED Red LED POWER SW BUTTON SOUND SW Internal view ID SW Power SW Sound SW DC Jack CON1 Battery Buzzer LED
INTERNAL SWITCHES: SW 1 : ID Code Switch SW 2 : Programming Switch Set Volume: SW2-1 & SW2-2 Set Hold Time: SW2-3 & SW2-4 Set Delay Time: SW2-5 & SW2-6 Set Alarm Length: SW2-7 & SW2-8 SW3 : Power ON/OFF switch SW4 : Sensor Type switch CONNECTORS: CON1 : Battery connector CON2 : Buzzer connector CON3 : External DC input (9V) JUMPERS: JP3 & JP4 : Sensor input NOTE: Both BED sensor and FLOOR sensor are currently available. BEAM sensor will be available with next model.
Step 4. Slide SW2-5 and SW2-6 up or down for your desired Alarm Activation Delay Time. Choices available are: 0, 2 or 4 seconds: 0 sec 2 sec 2 sec 4 sec SW2-5 DOWN UP DOWN UP SW2-6 DOWN DOWN UP UP Step 5. Slide SW2-7 and SW2-8 up or down for your desired Alarm Length. 15, 30, 60 seconds or continuous without automatic reset: Choices available are 15 sec 30 sec 60 sec Continuous SW2-7 DOWN UP DOWN UP SW2-8 DOWN DOWN UP UP Step 6.
GETTING STARTED: With a BED system: Step 1. Find a suitable location for the Patient Box to be installed. Step 2. Apply the AC Power. Step 3. Press and hold the Power Button for 2 full seconds. flash. The Green LED will light and begin to Step 4. Choose between JP3 and JP4 and plug the Sensor unit into the Patient Box. For a BED Sensor: Step 5a. Apply weight to the sensor pad to hear the activation beep. The system is now activated. For a FLOOR sensor: Step 5b.
Press the “HOLD” button on #2130 for one full second. #2130 sounds one beep to confirm the “HOLD” command and will hold the system for the Hold Length specified at programming step. Green LED stops flashing and Orange LED begins flashing You may press the Power Switch once to cancel the “HOLD” command at anytime before the Hold Length is expired, or #2130 will sound another beep when the Hold Length is up to warn the user.
Green LED stops flashing and Orange LED begins flashing You may press the Power Switch once to cancel the “HOLD” command at anytime before the Hold Length is expired, or #2130 will sound another beep when the Hold Length is up to warn the user. Orange LED stops flashing and Green LED starts to flash During the Hold Length period, #2130 ignores all signals received from the sensor After the Hold Length period expired, #2130 sounds one beep to indicate it is back in Monitoring Mode.