AL11 USER GUIDE – Draft Rev2 USER GUIDE AlertMaster AL11 Home Alert System Clarity, a Division of Plantronics, Inc. 4289 Bonny Oaks Drive, Chattanooga, TN 37406 Tel: 800‐426‐3738 Fax: 800‐325‐8871 E‐mail: claritycs@plantronics.com Website: www.clarityproducts.com ©2010 Clarity, a Division of Plantronics, Inc. All rights reserved. AlertMaster, Clarity and AL11 are trademarks or registered trademarks of Plantronics, Inc. Rev.
AL11 USER GUIDE – Draft Rev2 CONTENTS (TO BE LEFT EMPTY UNTIL FINAL VERSION IS CREATED; THIS PAGE SHOWS THE TABLE OF CONTENTS) 2|Page
AL11 USER GUIDE – Draft Rev2 IMPORTANT SAFETY INSTRUCTIONS When using your Clarity AL11, basic safety precautions should always be followed to reduce the risk of fire, electric shock and persons including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the product. 3. Do not use this product near a bathtub, wash basin, kitchen sink or laundry tub, in a wet basement, near a swimming pool or anywhere else there is water. 4.
AL11 USER GUIDE – Draft Rev2 ADDITIONAL SAFETY NOTES FOR CANADIAN USERS The following items are included as part of the CS‐03 Requirements. The standard connecting arrangement for the equipment is CA11A. This product meets the applicable Industry Canada technical specifications. NOTE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective operational and safety requirements.
AL11 USER GUIDE – Draft Rev2 INTRODUCTION Thank you for selecting the exciting new AL11 from Clarity. It has been designed to meet the highest quality standards to provide you with years of convenient and trouble‐free service. Please read these operating instructions thoroughly before using your notification system. Keep this manual for future reference. You must save your sales receipt as proof of purchase in the event that you need warranty service.
AL11 USER GUIDE – Draft Rev2 FEATURES IDENTIFICATION 6|Page
AL11 USER GUIDE – Draft Rev2 INSTALLATION Do not put any of the AlertMaster components on or next to metal surfaces, computers, televisions, microwaves or other areas with electrical equipment that can cause interference to the wireless system. The antenna should be fully extended (in vertical position) without interference.
AL11 USER GUIDE – Draft Rev2 Doorbell Battery The doorbell transmitter operates on one “23A” size battery (included). It normally lasts 8‐16 months and can be tested by watching the red power indicator light illuminate when the doorbell button is pressed. If the power indicator is faint or off, replace the battery.
AL11 USER GUIDE – Draft Rev2 OPERATIONS When the AlertMaster AL11 is activated, the lamp flashes for two minutes, or until the RESET button is pressed. The lamp flashes in these patterns: 1. Phone The phone indicator light illuminates when the phone rings. The lamp will flash for two seconds, off for four seconds and repeat. 2. Door The door indicator light illuminates when the doorbell button is pressed. The lamp will flash for two seconds, off for two seconds and repeat.
AL11 USER GUIDE – Draft Rev2 3. Lamp Control Press the center LAMP CONTROL button to turn the AlertMaster AL11’s lamp on and off. In order for the control to work, ensure that the lamp is turned on prior to plugging the lamp jack into the back of the AL11. CHANNEL SETTINGS The AlertMaster AL11 uses radio signals to communicate between the console unit and all of its accessories. For the accessories (Doorbell, Door Announcer) to activate the base unit, they all have to be on the same “channel.
AL11 USER GUIDE – Draft Rev2 1. Unplug AC cord and locate DIP switches on the back of the AL11 base unit. Lift rubber cover to access the switch. 2. Open the battery compartment of the doorbell to access DIP switches. 3. Change the switch position of each switch on both units using a ballpoint pen to slide the switches to different settings. All settings need to be identical for the system to work. 4.
AL11 USER GUIDE – Draft Rev2 TROUBLESHOOTING In case of difficulty, review the “Symptom and Remedy” list below. Make sure no part of the AlertMaster system is on or near metal surfaces or electrical equipment. Should the difficulty persist, contact Clarity or your authorized dealer for assistance. WARNING! DO NOT open the unit. You may be exposed to hazardous high voltage electricity. Symptom Cause and Remedy LAMP CONTROL button doesn’t work Lamp is not turned on prior to plugging it into AlertMaster.
AL11 USER GUIDE – Draft Rev2 OPTIONAL ACCESSORIES The AlertMaster AL11 is designed to work with optional wireless remote receivers and transmitters, each sold separately. A. AlertMaster Remote Receiver AL12 Flashes a connected lamp to notify you wherever the receiver is placed, such as the kitchen, living room, garage, bathroom, etc., up to 80 feet from the AlertMaster Model AL11 base console. B.
AL11 USER GUIDE – Draft Rev2 REGULATORY COMPLIANCE Important Information for Customers PART 68 OF FCC RULES INFORMATION This AL11 Notification System complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the bottom of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
AL11 USER GUIDE – Draft Rev2 If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this telephone equipment does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer. This telephone equipment is hearing aid compatible.
AL11 USER GUIDE – Draft Rev2 extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.
AL11 USER GUIDE – Draft Rev2 WARRANTY INFORMATION This warranty applies only to CLARITY products that are purchased and used in the United States, Canada or United Kingdom. CLARITY warrants the ALERTMASTER AL11 against any defect in materials or workmanship for the period of one year from the date of purchase. If your CLARITY product is defective and returned within 30 days of the date of purchase, your authorized Clarity dealer will replace it at no charge.
AL11 USER GUIDE – Draft Rev2 CLARITY, a Division of Plantronics 4289 Bonny Oaks Drive • Chattanooga, TN 37406 Tel: 800‐426‐3738 • Fax: 800‐325‐8871 E‐mail: claritycs@plantronics.com • Website: www.clarityproducts.