PHONES (044) 360-7-130 (050) 336-0-130 (063) 788-0-130 (067) 233-0-130 (068) 282-0-130 Internet store of autogoods ICQ 294-0-130 597-0-130 SKYPE km-130 CAR RECEIVERS — Receivers • Media receivers and stations • Native receivers • CD/DVD changers • FM-modulators/USB adapters • Flash memory • Facia plates and adapters • Antennas • Accessories | CAR AUDIO — Car audio speakers • Amplifiers • Subwoofers • Processors • Crossovers • Headphones • Accessories | TRIP COMPUTERS — Universal computers • Model compute
.u a QUICK START GUIDE & Installation Manual GUIDE DE DÉMARRAGE RAPIDE et guide d'installation KURZANLEITUNG und Montageanleitung GUIDA DI AVVIO RAPIDO e manuale di installazione BEKNOPTE HANDLEIDING & installatiehandleiding GUÍA DE INICIO RÁPIDO y Manual de instalación SNABBGUIDE OCH BRUKSANVISNING PODRĘCZNIK WPROWADZAJĄCY i podręcznik użytkownika ΟΔΗΓΟΣ ΓΡΗΓΟΡΗΣ ΕΚΚΙΝΗΣΗΣ & Εγχειρίδιο εγκατάστασης 13 0. c om NX302E MULTIMEDIA STATION WITH BUILT-IN NAVIGATION & 6.
Contents English This guide is intended to guide you through the basic functions of the unit. Notes 13 0. c om .u a Precautions............................................................................................................................ 2 Operational Panel.................................................................................................................. 3 Turning the Power On................................................................................................
Precautions English WARNING For your safety, the driver should not operate the controls while driving. Also, while driving, keep the volume to a level at which external sounds can be heard. .u a 1. This unit uses precision parts and components for its operation. In the event that trouble arises, never open the case, disassemble the unit, or lubricate the rotating parts. Contact your Clarion dealer or service center. 2.
Operational Panel [ ALL ] ALL MENU RESET [MIC] English [ ] NAVI/AV [POWER/VOL] Micro SD card slot om .u AUX Jack a Only navigation map card is available and don't remove it when unit is power on. Names of Buttons 0. c [POWER/VOL] Knob • Press to power on the system when ignition on. • When power on, short press to mute the volume. • Rotate the knob to increase or decrease the volume. • Press and hold this key more than 1 second to turn off the system.
Turning the Power On English Start the engine. The power is supplied to this unit. 13 0. c om .u a Press [POWER/VOL] button on the panel to turn on the unit. Selecting a Source Long press [ ALL ] button on the PANEL to show main source menu. Touch [ - ] on the bottom of screen to show sources. Change page by dragging left or right or touching other [ - ] buttons. Touch the icons on the screen to enter corresponding work mode, such as Disc mode, Tuner mode, Telephone mode, etc.
Source Media Modes English When you select the desired source mode (for example, the Tuner, USB or iPod mode), the following screen will appear. During playback, touch the bottom half of screen to show operation bar. 1. 2. 3. 4. 5. 6. 7. 8. 9. Show folder/file list (Browse) Folder/Title/Artist/Album information Play/Pause Repeat play Previous track Fast reverse (long press) Progress bar Next track Fast forward (long press) Random play Show other options 0. c om .u 10. Scan play 11.
Source Media Modes English iPod ® Audio Playback 1. 2. 3. 4. 5. 6. Show file list (Browse) Switch between iPod Audio and Video Song/Artist/Album information Play/Pause Repeat play Previous track Fast reverse (long press) 7. Progress bar 8. Next track Fast forward (long press) 9. Random play 10. Show other options om .u a 11. Turn on / off Simple Control 12. Select Audiobook play speed 13. Back to main operation bar 0. c iPod video playback 13 1. Play/Pause 2. Repeat play 3.
Source Media Modes English Radio mode Band switch Information area Preset station number Current station frequency Show preset stations list Scan preset stations Manual tune backward Auto tune backward. (long press) 8. Frequency bar 9. Manual tune forward Auto tune forward. (long press) 10. Show other options .u om 11. Choose local or distant seeking mode 12. Turn on/off Traffic Announcement 13. Turn on/off Alternative Frequency 14. Turn on/off Regional 15. Show next page 16.
Bluetooth Operations English Pairing 1. Touch [Custom] on the bottom left of the main menu, then select [Settings] to enter Setting menu. 2. Touch [Setup], then touch the button to the right of “Bluetooth” to show Bluetooth setting menu. 3. Select [On] to the right of “Bluetooth”. 4. Turn on Bluetooth function of your mobile phone. 5. Enter mobile phone’s Bluetooth setup menu. 6. Search for new Bluetooth devices. 7. Select NX302E from the pairing list on the mobile phone. 8. Enter the password.
Start using Clarion Mobile Map English When Clarion Mobile Map is started the first time, you need to do the following: 1. Select the written language of the application interface. Later you can change it in Settings. 2. Select the language and speaker used for voice guidance messages. Later you can change it in Settings. 3. Read and accept the End User Licence Agreement. 4. Read and accept the road safety warning. After this, the Navigation menu appears and you can start using Clarion Mobile Map.
Start using Clarion Mobile Map 12. To enlarge this small map and open the Map screen, tap [Show Map] button 13. Zooming in and out 14. Tilting up and down 15. Rotating left and right 16. 2D or 3D view 17. Compass in 2D map view mode 18. Compass in 3D map view mode 19. Location information 20. Return to normal navigation 21. Select destination Quick menu om 22. The Quick menu is a selection of controls and functions that are frequently needed during navigation.
Installation Guide English Before Starting 1. This set is exclusively for use in cars with a negative ground, 12 V power supply. 2. Read these instructions carefully. 3. Be sure to disconnect the battery “ ” terminal before starting. This is to prevent short circuits during installation. Car battery Package Contents .u a Owner’s manual (CD-R).............................1 Electro tap..................................................2 Flush mount bolts(M5x6)............................
Installation Guide English Installing The Main Unit This unit is designed for fixed installation in the dashboard. 1. When installing the main unit in NISSAN vehicles, use the parts attached to the unit (see “ NISSAN”). When installing the main unit in TOYOTA vehicles, use the parts attached to the vehicle (see “ TOYOTA”). 2. Wire as shown in “Wire Connection”. 3. Reassemble and secure the unit in the dashboard and set the face panel and center panel.
Installation Guide *1 Some panel openings are too small for the unit depending on the vehicle type and model. In such a case, trim the upper and lower sides of the panel frame by about 0.5 to 1.5 mm so the unit can be inserted smoothly. *2 If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper or similar tool. English Note: Vehicles other than NISSAN and TOYOTA In some cases the center panel may require modification. (Trimming, filling, etc.) marks. 0.
Installation Guide English Installing The GPS Antenna WARNING • Do not install the GPS antenna in a place where it may interfere with the operation of the airbag or hinder the driver’s visual range. • Do not use the navigation system with the GPS antenna cord cut off. The power cables in the cord may be short-circuited. Note: .u a • T he supplied GPS antenna is for installing inside the vehicle. Do not install it outside the vehicle.
NX302E Installation Guide English Wire Connection GPS GPS Antenna Antenna (Black) (Black) (Black) (Black) Radio RadioAntenna Antenna C B 1 2 3 4 5 6 7 8 Referto to next next page. Refer page. A 1 2 3 4 5 6 7 8 Black Black Black Black Line Out OutRear RearRight Right Line Subwoofer22 Subwoofer om Red Red Line Line Out OutRear RearLeft Left Subwoofer Subwoofer11 .
Installation Guide English B 18 16 14 12 10 8 6 4 2 Rear left - 1 3 5 7 Rear left + Front left Front left + Front right + 2 4 6 8 Front right Rear right + Rear right Fuse 15A Battery + C A 1 3 5 7 Parking ACC + a AUTO ANT AMP Remote Illumination .
Installation Guide *1 Connect to the AUX audio input terminal and the iPod video input terminal. (Audio connection is required only when [Analog] is selected for the iPod output signal. See Owner’s Manual.) *2 In certain vehicles - Volkswagen/Opel/Vauxhall - it is necessary to exchange the accessory <> and the main power <> connection, to avoid overload and loss of memory. *3 When the unit is installed in a 1998 or later Volkswagen model, make sure to interrupt the <> output.
English: Español: Declaration of conformity Declaración de conformidad We Clarion declares that this model NX302E is following the provision of Directive 1999/5/EC with the essential requirements and the other relevant regulations. Clarion declara que este modelo NX302E cumple con los requisitos esenciales y otras disposiciones aplicables descritos en la Directiva 1999/5/CE.