Owner’s manual CeNET iPod INTERFACE ® Clarion Co., Ltd. All Rights Reserved. Copyright © 2006: Clarion Co., Ltd.
English Contents 1. INTRODUCTION ............................................................................................................................ 3 2. CAUTION ....................................................................................................................................... 3 3. CONNECTION ............................................................................................................................... 4 4. INSTALLATION ..........................................
The interface adapter for iPod ® by Clarion, EA1276, works by simulating iPod into the main unit. Thus, iPod features can be controlled through iPod Menu in the main unit. The main unit will be able to display Playlists, Artists, Albums, Songs, Genres, and Composers for playback selection. For list of main unit compatible to EA1276, please consult your nearest Clarion dealer. For iPod operations, please refer to your iPod Owner’s Manual. 2.
English 3. CONNECTION Please consult your nearest Clarion dealer before attempting to connect EA1276 to your main unit and iPod. Improper connection might damage your main unit, EA1276 , iPod or your vehicle wiring. Please make sure the Yellow wire (Bus power lead) is connected on the CeNET compatible Main Unit (This wire usually has a 3 Amp Fuse inserted) connects to battery. If this wire is not connected, the iPod interface will not function.
English 4. INSTALLATION There are no moving parts in EA1276. However, caution must be taken to ensure minimum damage to the unit. Do not press, puncture or drop the unit at anytime. Install the unit where there is no direct sunlight, away from vents or high moisture areas and away from other vehicle electronic components. Using Velcro or Double-Sided Tapes Stick velcro or Doble-sided tape to the unit.
English 5. iPod CONNECTION Start-up After connecting your iPod to the EA1276, the iPod display will change to the following: To start iPod operations, change the main unit mode to iPod mode. Playback will start automatically from the last position of iPod. The display changes from: CONNECT g Start Playing It will display current track and total tracks available in the current category. If the iPod is not connected, the main unit will display “No iPod”.
• ALBUMS Here are the operations supported by EA1276 and can be controlled through the main unit. • SONGS • iPod Menu mode • COMPOSER • Category Direct Each category will have its own submenu. Please refer iPod for each category description and structure.
English Playlist EA1276 simulates the main unit as iPod. Therefore, it can support all the playlists in iPod. Note: Please refer Acceptable playlist for more information. Changing playlist Playback will start from the first song of the selected playlist when next/previous playlist function is performed. How to create playlist A playlist must be created in iPod prior to connection to the main unit. The main unit cannot be used to create a playlist. Please consult iPod Users Manual for playlist creation.
English 10. SPECIFICATIONS General Power Supply Voltage: 14 V DC, negative ground Current Consumption: Less than 1 A Weight: 0.5 kg Dimensions (Figure 1): 100 mm (Width) x 30 mm (Height) x 110 mm (Depth) Figure 1 11. IDENTIFICATION OF PARTS EA1276 Owner’s manual CeNET cable (2.
