User's Manual

RC-2U+RCS-5U Operation Instruction
A. Function
1. Random/Learning code.
2. Operation code is 24 bit address code and CRC check,repeat probability is 1 / 16,777,216.
3. Receiver has a built-in memory,it can remember the data for 10 years.
4. Remote control works up to 80 feet.
B. Diagram
C. Operation
1. Pull out insulating strip from battery cover of transmitter. Then press ON/OFF key to check whether it can
work. If LED indicator of transmitter turns on, it means this Transmitter works well.
2. Put Receiver into outlet, LED indicator of Receiver flashes. Enter into leaning mode.
Notes: Receiver will exit leaning mode after 29 seconds without any operation. Then please pull out Receiver
and operate again.
3. Press Transmitters ON/OFF key once to connect with Receiver.
4. Then you can use it normally by pressing Transmitters ON/OFF key. LED indicator turns on, it means power
is on. In contrast, power is off.
D. Specification
1. Battery:1 pc CR2032.3V
2. Radio Frequency: 433.92MHz
3. Receiver category:Class 3
4. Power supply:125VAC,60Hz.
Max.load: 15A Resistive or General purpose; 1250W 10A Tungsten, TV-5, 1/2HP .

Summary of content (2 pages)