Operation Instruction
Operation Instruction
SPECIFICATION
Remote Control Outlet
Model: RCS-13U+RC-13U
Voltage: 125VAC, 60Hz
Max.load: 15A Resistive or General purpose, 10A/1250W Tungsten, TV-5, 1/2HP
Remote battery: 1PC CR2032 3V
Radio frequency: 433.92MHz
Transmitter duty cycle<10%
Receiver category: Class 3
Operation distance:about 80 feet in open area
DIAGRAM
OPERATION
1.Put battery in the transmitter.
Open battery cover of the transmitter and put 1PC CR2032 3V battery in it.Then press ON or OFF button of the transmitter
once to check whether it can work. If LED indicator turns on, it means this transmitter works well.
2.Plug the receiver into an outlet.
This receiver is a “grounded” device. It is only intended for use with a three-pronged grounded outlet.
3.Pairing with transmitter
a.Once the receiver is plugged into the receptacle. LED indicator in the front right corner of the receiver is slowly flash.
Enter into leaning mode.
Please note: The receiver will exit leaning mode after 29 seconds without any operation. Then please pull the receiver out
and put it into the outlet again to pair.
b.Press ON button of the transmitter once to pair with the receiver. Once successfully, LED indicator of the receiver stops
flash and keeps on.
c.Now you can turn the receiver on/off by pressing button of the transmitter. LED indicator of the receiver turns on, it
means power is on. In contrast, power is off.
4.Clear the pairing
1.Pull receiver out and put it into the outlet again (LED indicator is slowly flash as learning mode).
2.Press OFF button of the transmitter, then LED indicator of receiver flashes quickly (3-4 seconds), which means pairing is
cleared. After that, receiver returns to learning mode. Total time is 29 seconds.
3.Unplug the receiver.
4.The receiver should now be unpaired with the remote
HELPFUL TIPS
1.The transmitted coded pattern is random/learning code. Repeat probability is 1/1,048,575.
2.One receiver can memorize maximum 10 different transmitters. If pair the eleventh transmitter, the first paired transmitter
will be cleared.
3.One transmitter can pair multiple different receivers and turn them on/off simultaneously.
WARNINGS
Risk of Electric Shock
- Keep children away.
- Do not use in wet locations.
- Do not plug two or more timers together.
- Always ensure the plug of any appliance is fully inserted into the timer outlet.
- If cleaning of the timer is required, remove from mains power and wipe timer with a dry cloth.