User's Manual

RC-10U+RCS-6U Operation Instruction
A. Function
1. Random/Learning code.
2. Operation code is 24 bit address code and CRC check,repeat probability is 1 / 16,777,216.
3. Every transmitter can control up to 4 channels (1ON,1 OFF,2ON,2OFF…etc). each channel can control
one certain receiver
4. Receiver has a built-in memory,it can remember the data for 10 years.
5. Remote control works up to 80 feet.
6. Battery life is 2 years.
B. Diagram
C. Operation
1. Open battery cover of Transmitter and put 2 AAA 1.5V battery in it. Then press any ON/OFF channel
to check whether it can work. If LED indicator of transmitter turns on, it means this Transmitter works
well.
2. Put Receiver into outlet, LED indicator shows slow flashing. Enter into channel selection mode.
Note: Receiver will exit channel selection mode after 29 seconds without any operation.
3. Press Transmitter’s A channel ON, B ON, C ON or D ON to match with Receiver. Once successfully,
LED indicator stops slow flashing, then you can turn this Receiver ON/OFF by pressing selected
ON/OFF channel.
4. Clean selected channel: Pull out Receiver and put in (LED indicator shows slow flashing as channel
selection mode), then press and hold OFF key of selected channel until LED indicator shows fast
flashing (3-4 seconds), which means selected ON/OFF channel is cleaned. After that, Receiver returns
to channel selection mode. Total time is 29 seconds.
5. Clean all selected channels: Pull out Receiver and put in (LED indicator shows slow flashing as
channel selection mode), then press and hold OFF key of ALL ON/OFF channel until LED indicator
shows fast flashing (3-4 seconds), which means all selected ON/OFF channels are cleaned. After that,
Receiver returns to channel selection mode. Total time is 29 seconds.
E. Specification
1. Battery:2 pc AAA 1.5V
2． Radio Frequency: 433.92MHz
3. Receiver category:Class 3
4. Power supply:125VAC,60Hz.
Max.load: 15A Resistive or General purpose; 1250W 10A Tungsten, TV-5, 1/2HP .