Operation Manual

ManualsBrandsCitronic ManualsAudioCDM 8 4 mkV

USER MANUAL

CDM8:4 mkV

Rackmount DJ Mixer

172.775UK

Version 1.0

MAIN FEATURES

 19” rack mountable (4U)

 45mm rail glide replaceable crossfader with assign/defeat

 3-band EQ on all stereo channels

 DJ mic + 2 vocal mic inputs for karaoke

 Internal digital delay or FX loop for vocal mics

 Front panel 3.5mm input for personal media player

 Individual gain control for each music channel

 Hi & Lo EQ for each mic channel

 12Vdc BNC output for console light

Summary of content (6 pages)

PAGE 1
USER MANUAL CDM8:4 mkV Rackmount DJ Mixer 172.775UK Version 1.0 MAIN FEATURES  19” rack mountable (4U)  45mm rail glide replaceable crossfader with assign/defeat  3-band EQ on all stereo channels  DJ mic + 2 vocal mic inputs for karaoke  Internal digital delay or FX loop for vocal mics  Front panel 3.
PAGE 2
PACKING CONTENTS    CDM8:4 mkV 19” DJ mixer IEC mains cable Instruction manual INTRODUCTION Thank you for purchasing the Citronic CDM8:4 mkV Rackmount DJ Mixer. This product is intended to give long term, reliable service in normal usage. Please read these instructions before use to avoid incorrect operation and to help outline the functions and controls. MAINTENANCE No user serviceable parts inside, refer all servicing issues to qualified service personnel. Clean with a lint-free dry or damp cloth.
PAGE 3
Stereo Section (9) (10) (11) (12) (13) (14) (15) (16) (17) (18) (19) (20) (21) (22) (23) (24) CH.1 PHONO/LINE – Input selector for channel 1, turntable or line input CH.2 CD/LINE – Input selector for channel 2, CD player or line input CH.3 CD/LINE – Input selector for channel 3, CD player or line input CH.4 PHONO/LINE/MP3 – Input selector for channel 4, turntable or line/MP3 player MP3 IN – 3.
PAGE 4
Rear Panel (33) Mains inlet – IEC connector to connect to mains using the supplied lead (34) Fuse Holder – 20mm mains fuse holder - please note correct rating when replacing (35) RETURN L+R – When these 6.3mm jacks are connected to the outputs of an external processor, the output of the external unit will override the internal digital delay effect for Vocal mics 1 + 2. (36) SEND – Mono 6.3mm jack to connect to the input of external processors, sending the effect mix from Vocal mics 1 + 2.
PAGE 5
OPERATION                           Check mains for correct voltage as indicated near to the IEC mains inlet on the rear panel. Connect to mains supply using the IEC cable provided. Connect the Main unbalanced RCA and/or balanced XLR outputs to the main PA and ensure that the volume levels are turned down to avoid damage. Connect the BOOTH outputs to powered booth monitors or separate PA zone. Connect any turntables to the RCA PHONO inputs on ch.1 and ch.2.
PAGE 6
TROUBLESHOOTING NO OUTPUT Check mains power is on Check leads and connections Check MASTER LEVEL and mic or channel fader is turned up Check CROSSFADER by trying the DEFEAT switch DISTORTED OUTPUT Check line input isn't connected to PHONO Check channel and MASTER faders are not too high Check volume control of amplifier, active speakers or recording equipment MICROPHONE FEEDBACK Eliminate “line-of-sight” between mic(s) and speakers Check DELAY is not set too high Adjust Hi or Lo EQ and/or level controls MIC