Installation Guide

ManualsBrandsCisco ManualsElectronicsWireless Sensor

MT12-HW Installation Guide

MT12 Overview

The Cisco Meraki MT12 is wireless Bluetooth-enable sensor product. The MT12 is designed to be deployed

primarily in a networking environment (e.g., network closet) alongside Meraki equipment enabling the end-

user to receive alerts from the device specific to moisture and water leaks.

Package Contents and Wall Mount Hardware

In addition to the MT12, the following are provided:

Installation Instructions

Note: Each MT12 comes with an instruction insert within the box. This insert contains detailed step-by-

step guides and images to assist in the physical installation of the camera. A pdf can be found here.

(Note—this is a draft hyperlink not active yet.)

Summary of content (8 pages)

PAGE 1
MT12-HW Installation Guide MT12 Overview The Cisco Meraki MT12 is wireless Bluetooth-enable sensor product. The MT12 is designed to be deployed primarily in a networking environment (e.g., network closet) alongside Meraki equipment enabling the enduser to receive alerts from the device specific to moisture and water leaks. Package Contents and Wall Mount Hardware In addition to the MT12, the following are provided: Installation Instructions Note: Each MT12 comes with an instruction insert within the box.
PAGE 2
Note: During first time setup, the MT12 will automatically update to the latest stable firmware. Some features may be unavailable until this automatic update is completed. This process may take up to 10 minutes due to enabling of whole disk encryption. Wall Mount Hardware Setup The MT12 has multiple options for mounting to a surface. A mounting plate and two screws allowing it to be mounted to a wall using screws. If necessary, two drywall anchors are included to help if the wooden stud cannot be located.
PAGE 3
Pre-Install Preparation You should complete the following step before starting to configure the device which is to attach the MACBL-LEAK-1 cable to the device as shown below. Examples of Placement Locations Here are some examples of where the MT12 can be setup and placed in a networking environment.
PAGE 4
Configure your MT12 in the Networking using Dashboard The following is a brief overview only of the steps required to add a MT12 to your network. For detailed instructions about creating, configuring, and managing Meraki IoT networks, refer to the online documentation (https://documentation.meraki.com/MT). 1. Login to http://dashboard.meraki.com. If this is your first time, create a new account. 2. Find the network to which you plan to add your MT12(s) or create a new network. 3.
PAGE 5
Assigning IP Addresses At this time, the MT12 does not support static IP assignment. MT12 units must be added to a subnet that uses DHCP and has available DHCP addresses to operate correctly. Login to Meraki Dashboard Login to dashboard.meraki.com Technical Specifications Operational Temperature -18ºC to 55ºC degrees Dimensions: Length: 4.61 inches Width: 2.59 inches Height: 1.
PAGE 6
Regulatory Statements EU Radiation Exposure Statement Installing or mounting of this device shall be done as such that a minimum separation distance (distance between a person and the device, or the device’s antennas) of 20 cm is always ensured.
PAGE 7
Industry Canada Statement This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
PAGE 8
Statement CS-0438 - 台灣 RoHS 台灣RoHS“限用物質含有情況標示聲明書”網址 www.cisco.com/go/taiwanrohs Statement CS-0438 - Taiwan RoHS Taiwan RoHS “Restricted Substances Content Disclosure Table” web address www.cisco.