Mar 17 °00 15:49 _ P.
Mar 17 °00 15:50 P.02 —e LEC FCC Compliance Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (13 this device may not care hamlet interference, and (2) this device must accept any Interfaces pervasive, including interference that may cause undesired operation. . NOTE This equipment has bore toted and found to comply with the limits Yor a Class B digital device, sourpuss io Pat 18 of the FCC rules.
Mar 17 700 15:50 P.04 Fast.
Har 17 "00 15:51 POS Frost Ethernet Cord Section 1 Introduction Your Pleased adapter is a Fast Theme PCT adapter that implements the 3-bitwide, end bus mastering interface, The Fast Ethernet PCI adapter is bused upon Industry Standard PCI locate bus specification revision 2.0 and 2.2, that endures the function, making it fully auto-configurable. The Fast Ethernet PCT adapter is a dusk-sproad adapter connected to an Ethernet network with a single connection over shielded twisted-pair (UTP) cable.
Mar 17 *00 15:51 P.06 ———L ENE CE Section 2 Card Installation This section describes how to install your Ethernet adapter. Perform the following steps to install the adapter. 1. Tur off your computer and ali peripherals. 2. Make a note of the cables and chords tat are con. nested 10 the computer and disconnect them. 3, Remove your personal computer's cover (refer to the owner's mans! of your personal computer). 4. Select any available bus mastering PCI slot, and remove the slot cover. 5.
Mar 17 *00 15:52 P.08 —— ELEV Section 4 Configuration and Diagnosis Your Theme adapter is automatically configured when ysu power-up your computer, In certain however, you must modify your BIOS by entering your COS SETUP utility. To view the configuration perimeters assigned by the BIOS, insert the software diskettes into your drive aod execute the utility software, by typing SOMERSET.
Mar 17 00 18:52 P.03 it Ethernet Curd Section § BOOT ROM Installation (Adoption) The optional BOOT ROM device allows you ta soar net a diskettes workstation to the network. Perform the following steps to install your BOOT ROM device. Linger the BOOT ROM into the socket on the adapter. 2. Execute the SOMERSET file 1 enable the BOOT ROM function by selecting the appropriate BOOT ROM address from the configuration man. 3. Refer 10 the installation procedure provided by you Networking Operating System.
Mar 17 00 15:52 P. 10 AE Cor Beeton 6 Card Specifications [EEE 8023 standards: ABASE-T sod 100BAYETX Wiring Connector RAS Bus Characteristics: 32 bits bus master; PCL focal bus revision 2.0 ant 22 MO odds: Assigned by the BIOS to a free 1/0 address block IRC Line: ANTI, assigned by the BIOS tw a free IRQ (interrupt) amber Dimensions: w! BOOT ROM 120mm x 60mm 4.12% x 236%) wio BOOT ROM 120mm x 45mm (4.724% 1.
Mar 17 '00 15:52 P.11 mF Macaulay Section 7 Understanding the status LED IVI0OBASE-TX Indicators The green 100 Bps LED snd frees LNK LED indicate the connecting status on the port for either speed.