FCC Compliance Statement This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE ‘This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
This Class B digital apparatus meets ail requirements of the Canadian Interference-Causing Equipment Regulations. Cet apparel numeric de 1a Class B respect routes les exigences du Regalement sur fe materiel derailleur du Canada. CE Compliance Statement We hereby certify that the PCI Ethernet adapter complies with the EN 50081-1 and EN 50082-1 requirements.
— di Eth a ard CONTENTS FCC Compliance Statement... CE Compliance Statement Section 1 Introduction Section 2 Card Installation Pr Section 3 Configuration and Diagnostics... Section 4 Drivers Installation omen. Section § BOOT ROM Installation ..
ERR Cli Section 1 Introduction Your PC-based adapter is a Fast Ethernet PCI adapter that implements the 32-bit~ wide, and bus mastering interface. The Fast Ethernet PCI adapter is based upon Industry Standard PCI local bus specification revision 2.0, that features the function, making it fully auto configurable. ‘The Fast Ethernet PCI adapter is a dual-speed adapter connected to an Ethernet network with a single connection over shielded twisted-pair (UTP) cable.
Section 2 Card Installation ‘This section describes how to install your Ethernet adapter, Perform the following steps to install the adapter. » Tum off your computer and all peripherals. Make a note of the cables and cords that are connected to the computer and disconnect them. Remove your personal computer's cover (refer to the owner's manual of your personal computer), . Select any available bus mastering PCI slot, and remove the slot cover. .
———S Eh ee Section 3 Configuration and Diagnostics Your Ethernet adapter is automatically configured when you power-up yer computer, In certain computers, however, you must modify your BIOS by entering your COS SETUP utility. Ta view the configuration parameters assigned by the BIOS, insert the software diskette into your drive and execute the utility software, by typing EXERTS.
lle bard Section 4 Drivers Installation Before you connect your Fast Ethernet PCI adapter to the network, you have to install the network driver first. You should use the network driver supplied by the software diskette that is compatible with your Network Operating Systems. ‘The network driver for cache Network Operating System is under a separate directory. Each directory includes a REAMED. TXT file to describe the detailed installation procedures. A RELEASE.
Section 5 BOOT ROM Installation The optional BOOT ROM device allows you to connect a disk less workstation to the network. Perform the following steps to install your BOOT ROM device. Insert the BOOT ROM into the socket on the adapter. Execute the EXERTS fic to enable the BOOT ROM function by selecting the appropriate BOOT ROM address from the configuration menu. . Refer to the installation procedure provided by your Networking Operating System.
AR kil Section 6 Card Specifications IEEE 802.3 standards: Wiring Connector: Bus Characteristics: 1/0 address: Airline: Dimensions: Emission Compliance: Immunity Compliance: Power Consumption: Operating Temperature: Operating Humidity: ABASE-T and $00BASE-TX RI-45 32 bits bus master; PCi local bus revision 2.0 Assigned by the BIOS to a free VO address block ANTI; assigned by the BIOS to a free IRQ (interrupt) number 472" x 2.
Section 7 Understanding the status LED Indicators The green 100 Bps LED and green LNK LED indicate the connecting status on the port for either speed.