Ethernet Card Jor PC CONTENTS FCC Compliance Statement Section 1 Introduction Section 2 installation .. 3 Section 3 Configuration and Diagnostics 6 7 Section 4 Drivers Installation .. Section 5 Boot ROM installation ..newswomen § Section § Cable Specifications 2 Section 7 Troubleshooting Section § Specification wvevavnmmasnsann {1 Hoa pres 3 GAS, AM 10.
Herder pros Ethernet Card jor PC] Section 2 Installation This section describes how to install your Ethernet hub card. Perform the following steps to install the adapter. Turn off your computer and all peripherals. Make 2 note of the cables and cords that are connected to the computer and disconnect them. Remove your personal computer's cover (refer io the owner's manual of your personal computer). Select any available PCI slot, and remove the slot cover.
| : | Ethernet Card for PCI Section 4 Drivers Installation Be sure to install the proper driver for the hub card to provides « connection between the MAC interface and the four ABASE-T node. The Ethernet hub card is fully IEEE 802.3 compatible and can use the Net Ware SODIUM NE2000 compatible driver that is included in your Networking Operating System You can also use the driver supplied by the software diskette that is compatible with your Networking Operating System.
Maximum Attenuation: 810 10dB per 100m at 10Mz Section 7 Troubleshooting “This section describes reasons for some adapter's failures and the actions (0 be taken to resolve the problems. * PCH scan specified, device not found Action: Verify that the PC} Theme adapter is physically installed properly. Otherwise, replace the adapter. Connection failure if using an shielded twisted pair (UTP) cable Action: Verify that the UTP cable is firmly attached. HOME pmS 9 1998215. AM 10.
Holler pms Section 8 Specifications IEEE 802.3 Standard: Wiring Connector: Bus Characteristics: FO address: IRQ line: RAM buffer: Dimensions: FCC Compliance: Power Consumption: Operating Temperature: Operating Humidity: ABASE-T RI-45 32 bits ; PCI Local specification 2.
Hollie pe Ethernet Card forceful Section 6 Cable Specifications “The Ethernet adapter has three connector alternatives. Each connector requires a different cable. This section describes each cable's specification.
Herod pbs Ethernet Card forceful Section 3 Configuration and Diagnostics Your Ethernet hub card has built-in a MAC interface which is automatically configured when you power-up your computer, In certain computers, however, you must modify your BIOS by entering your COS SETUP utility. To view the configuration parameters assigned by the BIOS, insert the software diskette into your drive and execute the utility software, ECLIPSE 6 1998/85.
Hed pme Ethernet Card forceful Section 1 Introduction Your Ethernet hub card is a high performance network device that is designed to easily link four ABASE-T hub with a PCT interface card. The hub card consists of four (4) ABASE-T hub port to linking and forwarding packets in one segment, it also includes a 32-bit PCI interface to provide an additional connection with the network segment.
| EXHIBIT 1 FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.