Ethernet Card forceful FCC Compliance Statement This device complies with Part 15 of the FCC rules Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Pact 15 of the FCC Rules.
Ethernet Card for PCI FCC Compliance Statement mie.
Ethernet Card forcible Section 1 Introduction Your Ethernet bub card is a high performance network device that is designed to easily link four 10/100Mbps hub with a 100Mbps PCI interface card.
Ethernet Card for PCI Section 2 Installation This section describes how to install your Ethernet hub card. Perform the following steps to install the adapter. Tum off your computer and afl peripherals. 2. Make a note of the cables and cords that are con. nested to the computer and disconnect them. Remove your personal computer's cover (refer to the owner's manual of your personal computer), . Select any available PCI slot, and remove the slot cover.
Ethernet Card forceful Section 3 Configuration and Diagnostics Your Ethernet hub card has built-in a 100Mbps MAC interface which is automatically configured when you power-up your computer, In certain computers, however, you must modify your BIOS by entering your COS SETUP nativity.
Ethernet Card for PCI Section 4 Drivers Installation Be sure to install the proper driver for the hub card to provides a connection between the 100Mbps MAC interface and the four 10/) 00Mbps nodes, You can use the drivers supplied by the software diskette that is compatible with your Networking Operating System. The driver for each Networking Operating System is under a separate directory. Each directory includes a REAMED. TXT file to describe the detailed installation procedure. A RELEASE.
Ethernet Card formic{ Section 5 Cable Specifications The Ethernet adapter is equipped with for JR-43 connectors, the JR-45 connector requires a corresponding cable. This section describes such cable's specification, «Cable for RI-45 connector for 10Mbps network Cable type: UTP with 2 twisted pairs of 22,240r26 AWG Category: 3,4,05 Twists per font: 2to3(min.) Nominal impedance: 100 ohms Maximencablelength; 300(100m) Mnxivnum Attenuation: per 100m at 10Mz.
er net Card for PCI Section 6 Troubleshooting This section describes reasons for some adapters failures and the actions to be taken to resolve the problems. «PCT scan specified, device not found Action: Verify that the PCI Theme adapter is physically installed properly. Otherwise, replace the adapter, Connection failure if using an shielded twisted pair (UTP) cable Action: Verify that the UTP cables firmly attached and the cable type is correct for use.
Ethernet Card yor Section 7 Specifications TEE 802.3 Standard: Wiring Connector: Bus Characteristics: TO address: IRQ line: Dimension FCC Compliance: CE Compliance: Power Consumption: Operating Temperature: Operating Humidity: ABASE-T {00BASE-TX JR-45 bits ; PCT Local Bus specification 2.
USER INFORMATION NTO THE USER WRECKER SE kr kon a This device complies with part 15 of the FCC Rules cation is subject to the following two conditions: tL This diva 2 May not cays harmony interference, and (21 This device MUSE accept anv interference received, including incarcerate Dat may cause undesirable operation, NOTE: This equipment has been tested ang found to comply with the limits for 4 Class B digital device, Furs ant to Part 183 of the FCC Rules.