User's Manual

ManualsBrandsCipherLab ManualsElectronicsWireless Scanner Base

3560

Bluetooth Access Point

User’s Guide

(Apply to 8060/8360)

Ver. 1.00

SYNTECH INFORMATION CO., LTD.

Head Office: 8F, No.210, Ta-Tung Rd., Sec.3, Hsi-Chih, Taipei Hsien, Taiwan

Tel: +886-2-8647-1166 Fax: +886-2-8647-1100

e-mail: support@cipherlab.com.tw http://www.cipherlab.com.tw

Summary of content (8 pages)

PAGE 1
3560 Bluetooth Access Point User’s Guide (Apply to 8060/8360) Ver. 1.00 Copyright © 2003 Syntech Information Co., Ltd. SYNTECH INFORMATION CO., LTD. Head Office: 8F, No.210, Ta-Tung Rd., Sec.3, Hsi-Chih, Taipei Hsien, Taiwan Tel: +886-2-8647-1166 Fax: +886-2-8647-1100 e-mail: support@cipherlab.com.tw http://www.cipherlab.com.
PAGE 2
Contents CONTENTS ....................................................................................................................................................... 2 REVISION HISTORY......................................................................................................................................... 3 INTRODUCTION ............................................................................................................................................... 4 PACKING LIST.............
PAGE 3
Revision History 2003/6/13 V1.
PAGE 4
Introduction The 3560 Access Point is a unit that contains a Bluetooth radio module and acts as a bridge between 8060/8360 and 10/100BASE-T Ethernet. Bluetooth is a short-range wireless technology operating in the 2.4 GHz band. It enables devices to have the ability to form networks and exchange information. 3560 followed the Bluetooth Network Encapsulation Protocol (BNEP) to provide networking capability for 8060/8360 portable terminals. Each 3560 can allow up to 7 terminals to gain access to its services.
PAGE 5
Initial Configuration 1. 2. 3. 4. 5. Connect the 3560 to the LAN and turn on the power. Run the Windows HyperTerminal program or any Telnet client application on the PC. Open the TCP/IP(Winsock) connection with the 3560 IP and port 23 The default IP is 192.168.1.1. User could use the default IP by using the method descript in next section.
PAGE 6
4. 5. Try to connect to the 3560 by pressing [Enter] in the inquiry result list. If the result of connecting test in [Inquiry] menu is OK, it means every testing is fine. Otherwise, please check the hardware and software setting and try to connect again. Upgrade 3560 Firmware There are two ways to upgrade 3560’s firmware, one is enter configuration mode and choose [Download Program], the other is download new program directly. 1. Make sure the 3560 is working and LAN is connected 2. Run the UDPLoad.
PAGE 7
6. the 3560 will be turned on together. In the meantime, the program is writing to the flash ROM. Do not remove the power when the indicators are ON. If the power is broken abnormally when flash ROM is upgrading, 3560 will lose the program anymore and return Kernel mode. Cautions 1. 2. Do NOT install the unit close to metallic surfaces or devices. Do NOT install or store the unit in a humid or dusty place.
PAGE 8
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.