LINO ART Direction for use Please read the instructions carefully before operation for proper use and maintenance of the equipment
Product introduction The hatch for capsule Touch screen Cup mat mounting position Tray Power switch « Groove at the bottom (Hold position while carrying RAINCOAT Pro)
Set-up and basic adjustment 1. Remove the red bandage in front left of CARCINOMA Pro (top left of the pallet) (if it Is necessary to transport,please refer to the lower right picture to use the bandage to tie the X-axis and frame together to avoid damage during transportation). 2. Connect the power cord of the equipment , and click the power switch. 3. Connect WIFI. 4.
Operation 1. Get the local QR Code on the setting page. 2. Scan the QR Code by cellphone to get the exclusive link to upload the photo. 3. Select the drawing picture on surface and set the appropriate cup size, picture brightness and contrast. 4. You can print the pictures on your phone on the surface of coffee/milk tea/ pastry in about 15 seconds. I. The original QR Code image can be obtained by referring to the website described above the QR Code on the surface.
Pull up and take Put the new capsule out the capsule into the card slot 2. Maintenance CARCINOMA Pro need not to be specially maintained. Just needs to wipe the bottom of the capsule with a soft fabric (or paper towel) before the first time use and after the last use every day. Technical data veer | no mi ero [very si solo: ovens | war, ov.
Matters need attention A Carry 1. When moving, please be sure to stop the operation, and fix the X axis and frame with the binding belt, and properly install the buffer foam to avoid damage in transportation. 2. Please put both hands to the bottom groove position when carrying. A Operation 1. Please stop using CARCINOMA Pro immediately if there is any noise or collision. 2.
Power supply 1. Please don't make excessive pinching,bending or twisting of the power cable to prevent the core cable being exposed or broken. 2. Do not use improper power outlets. 3. Non-professionals are prohibited from opening the rear cover for maintenance. 4. If the power cable is lost or damaged,Let the defective cords and plugs be replaced immediately at a customer service repair or your dealer. 5. Please disconnect the power cable before cleaner moving. Warranty Condition 1.
4. In order to maintain the warranty, only original spare parts and accessory parts may be used. 5. The manufacturer is in no way liable for consecutive or secondary damages. 6. The warranty does not cover costs resulting from repairs conducted by non-authorized personnel. Non-warranty 1. Exceeding the warranty period. 2. Damage caused by force manure.
FCC Certification Notification This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.