Installation Manual
Table Of Contents
ClareOne Panic Keyfob Installation Manual
CLR-C1-PNC
CLR-C1-PNC IM V3 05012020
Description
The CLR-C1-PNC is a lithium battery (replaceable) powered operated panic device for an alarm system. The Panic
provides the user: (specific programming required for operation)
• Police alarm sounds.
• Medical reporting.
• Silent alarm reporting.
• Auxiliary (local only sounds).
Programming
The following steps describe the general guidelines for programming the sensor into panel memory. Refer to the
specific panel’s documentation for complete programming details.
Note: In programming, the sensor should be enrolled in a supervised group, this maintains integrity between the panel
and device.
Enter panel learn-in/enrollment mode.
1. Select sensor number.
2. Select sensor type (specific for panel).
3. When the panel request sensor activation.
4. Press the Panic button 2 times within 1 second.
5. Exit program mode.
Testing and the Sensor
Sensor should be tested for both operation and range.
Operational Testing
• Press the Panic button 2 times within 1 second, the specific alarm sound should immediately sound.
• Disarm the system to silence the alarm.
Wireless Testing
Wireless testing provides a baseline for the distance the panic will operate away from the control panel.
• Enter dealer sensor test at the control panel.
• Press the Panic button 2 times within 1 second and verify panel acknowledgement.
• Walk away from the panel and test at various locations making sure the panel acknowledges.
Note: Non-supervised sensors should be tested weekly to ensure proper operation.
Battery Replacement
Note: If a low battery alarm occurs, replace the battery within 7 days.
The CLR-C1-PNC requires (1) 3-VDC, lithium coin-cell batteries (Varta or Panasonic, Model CR2032),
1. Remove the cover
2. Remove the circuit board
3. Observe polarity when replacing battery.
CAUTION: Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire.