User's Manual

Mini DW Ext Term - Tilt—Installaon Instrucons
Mini DW Ext Term - Tilt Sensor
1 - Tilt Sensor 1- Mounng Tape 2 - Baeries ( 2- 3VDC CR 2032) Instrucons
Tamper
switch
Doc # I-RF-MDWSX Rev. A Jan 2015
Installaon
1. Remove the transmier’s cover by pressing in on
the small rectangular latch on the end of the cover
and li up
2. Mount the sensor base directly to the surface us-
ing the mounng tape provided.
3. Remove the baery isolator tabs from both baer-
ies on the sensor
4. Replace the cover on the transmier
5. Enroll the senor into the control panel according
the instrucons
Note: Mounng the transmier onto metal surfaces
may impact the eecve range of the transmier
Cover
Latch
Cover
Latch
Tamper
Base
Note: Baery Safety
Observe polarity when inserng
replacement baeries to avoid dam-
aging the sensor.
Risk of re, burns and explosion. Do
not recharge, disassemble, burn or
expose baeries to temperatures
above 100C (212F)
Dispose of used baeries properly
and in accordance with all local laws
Keep baeries away from children
Baeries
Tilt Sensor
The Tilt sensor is designed to mount on an overhead
garage door, and provide and open/close indicaon.
Mini DW Ext Term - Tilt—Installaon Instrucons
Mini DW Ext Term - Tilt Sensor
1 - Tilt Sensor 1- Mounng Tape 2 - Baeries ( 2- 3VDC CR 2032) Instrucons
Tamper
switch
Doc # I-RF-MDWSX Rev. A Jan 2015
Installaon
1. Remove the transmier’s cover by pressing in on
the small rectangular latch on the end of the cover
and li up
2. Mount the sensor base directly to the surface us-
ing the mounng tape provided.
3. Remove the baery isolator tabs from both baer-
ies on the sensor
4. Replace the cover on the transmier
5. Enroll the senor into the control panel according
the instrucons
Note: Mounng the transmier onto metal surfaces
may impact the eecve range of the transmier
Cover
Latch
Cover
Latch
Tamper
Base
Note: Baery Safety
Observe polarity when inserng
replacement baeries to avoid dam-
aging the sensor.
Risk of re, burns and explosion. Do
not recharge, disassemble, burn or
expose baeries to temperatures
above 100C (212F)
Dispose of used baeries properly
and in accordance with all local laws
Keep baeries away from children
Baeries
Tilt Sensor
The Tilt sensor is designed to mount on an overhead
garage door, and provide and open/close indicaon.