User's Manual
Mini DW Ext Term - Doorbell - Installaon Instrucons
Mini DW Ext Term - Doorbell Sensor and Accessories
1 - Mini DW Ext Term-Doorbell Sensor 1- Mounng Tape 2 - Baeries ( 2- 3VDC CR 2032) Instrucons
Tamper
switch
Doc # I-RF-MDWSX-DB Rev. A Jan 2015
Cover
Latch
Cover
Latch
Tamper
Base
Note: Baery Safety
Observe polarity when inserng
replacement baeries to avoid dam-
aging the sensor.
Risk of re, burns and explosion. Do
not recharge, disassemble, burn or
expose baeries to temperatures
above 100C (212F)
Dispose of used baeries properly
and in accordance with all local laws
Keep baeries away from children
Baeries
Leads
The Mini Doorbell Sensor is designed to wire directly to
the exisng doorbell circuit, providing a wireless signal to
the control panel, alerng the user.
The Doorbell Sensor can report 2 independent doorbells,
each reporng its own ID number.
Programming:
1. Enter system programming on the Qolsys panel
2. Enter Auto Learn Sensor
3. Trip tamper on sensor for rst reporng zone
4. Enter sensor name and group, Add New
5. Trip tamper a second me for second reporng zone
6. Enter sensor name and group, Add New
Mini DW Ext Term - Doorbell - Installaon Instrucons
Mini DW Ext Term - Doorbell Sensor and Accessories
1 - Mini DW Ext Term-Doorbell Sensor 1- Mounng Tape 2 - Baeries ( 2- 3VDC CR 2032) Instrucons
Tamper
switch
Doc # I-RF-MDWSX-DB Rev. A Jan 2015
Cover
Latch
Cover
Latch
Tamper
Base
Note: Baery Safety
Observe polarity when inserng
replacement baeries to avoid dam-
aging the sensor.
Risk of re, burns and explosion. Do
not recharge, disassemble, burn or
expose baeries to temperatures
above 100C (212F)
Dispose of used baeries properly
and in accordance with all local laws
Keep baeries away from children
Baeries
Leads
The Mini Doorbell Sensor is designed to wire directly to
the exisng doorbell circuit, providing a wireless signal to
the control panel, alerng the user.
The Doorbell Sensor can report 2 independent doorbells,
each reporng its own ID number.
Programming:
1. Enter system programming on the Qolsys panel
2. Enter Auto Learn Sensor
3. Trip tamper on sensor for rst reporng zone
4. Enter sensor name and group, Add New
5. Trip tamper a second me for second reporng zone
6. Enter sensor name and group, Add New