Installation Instructions

ManualsBrandsCIMCON ManualsElectronicsPhotocontroller

Page 1

Installation and Commissioning Procedure

For iSLC4100-7P-T

CIMCON Lighting, Inc.

ISLC4100-7P-T

Place the Photocontroller into the 7-pin NEMA receptacle and rotate it clockwise to lock.

Fig. 1 Installation of ISLC4100-7P-T on the luminaire

Summary of content (5 pages)

PAGE 1
Installation and Commissioning Procedure For iSLC4100-7P-T CIMCON Lighting, Inc. ISLC4100-7P-T Place the Photocontroller into the 7-pin NEMA receptacle and rotate it clockwise to lock. Fig.
PAGE 2
Installation Procedure ISLC4100-7P Fig.
PAGE 3
Installation Procedure ISLC4100-7P The cables protruding from the receptacle have following function as mentioned into table. Once the Photo-controller is installed and luminaire is powered ON then depending on the daylight condition Lamp will operate. In the Lab environment, you can just cover the cap with cloth or by hand and see the Lamp turning ON if wired correctly and if you remove the cloth, it will turn OFF.
PAGE 4
Installation Procedure ISLC4100-7P  PHOTOCONTROL MUST BE LOCKED IN! Note: window or arrow on top of SLC should be pointed away from the mounting surface. The receptacle/socket may be repositioned by loosening the screw in the center of the receptacle/socket. Rotate to the new position and retighten screw. Do not rotate receptacle/socket over 360 degrees because you can twist receptacle/socket wires. Eventually stripping the insulation and cause the fixture to fail.
PAGE 5
Installation Procedure ISLC4100-7P FCC RF Radiation Exposure Statement: Mobile Device This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Canada (IC) statement: Labeling requirements for Industry Canada are similar to those of the FCC.