User's Manual

ManualsBrandsCIMCON ManualsElectronicsPhotocontroller

Page 1

Installation, Commissioning and user manual

For iSLC3500-C

CIMCON Lighting, Inc.

ISLC3500-C

1. MECHANICAL Mounting

Unit fixed over screw mounted studs inside fixture / Panel housing as per field installation condition.

[Image-1: Screw fixed inside light fixture, example image only]

[Image-2: Screw fixed with over mounting stud inside fixture, example image only]

Summary of content (5 pages)

PAGE 1
Installation, Commissioning and user manual For iSLC3500-C CIMCON Lighting, Inc. ISLC3500-C 1. MECHANICAL Mounting Unit fixed over screw mounted studs inside fixture / Panel housing as per field installation condition.
PAGE 2
Installation Procedure ISLC3500-C External dipole antenna interface is through RF co-axial extension cable. - RP-SMA female RF connector there on iSLC3500-C body RF extension cable one end to connect at iSLC3500-C body. Other end of the RF extension cable to connect with external antenna which is fixed at its mounting plate / location over light fixture housing.
PAGE 3
Installation Procedure ISLC3500-C 2. Electrical Connections Field wiring to be done using appropriate connectors. Example from ‘WAGO 221’ series Splicing Connector (UL file ‘ZMVV.E69654) OR any other equivalent. [Image-4: Field wiring diagram] [Image-5: Field wiring through WAGO terminals, example image only] Once the Controller is installed and luminaire is powered ON then depending on the scheduled configuration condition Lamp will operate.
PAGE 4
Installation Procedure ISLC3500-C Safety Consideration for the Installation crew: • Ensure that the supply voltage matches the SLC’s voltage rating. • Tightly secure the SLC into the fixture slot provided with appropriate screws. FCC Warning statement FCC ID: 2ALSZ-CL3500C 15.19 This device complies with Part 15 of the FCC Rules.
PAGE 5
Installation Procedure ISLC3500-C FCC RF Radiation Exposure Statement: Mobile Device This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Canada (IC) statement: Labeling requirements for Industry Canada are similar to those of the FCC.