User's Manual

ManualsBrandsCHY ManualsElectronicsWireless Module

VEABT009 Module

User's Manual

1. Features

- On-chip low power microcontroller

- Up to 1024 kB flash program memory

- Up to 96 kB RAM data memory

- On board crystal and PCB Antenna

2. Application

- Mobile device accessories (Android/ iOS)

- Wireless data communication

- Remote sensors

3. Pin definition (from right to left)

Pin No.

Description

Pin Type

Functions

BLE_RX

Digital I/O

UART RX

BLE_TX

Digital I/O

UART TX

WAKE_UP

Output

Digital I/O

STATUS

Input

Digital I/O

GND

Digital I/O

GND

V+

Digital I/O

VDD

BLE_EN

Digital I/O

VDD Enable

4. How to use:

- Before sending any UART Command, "WAKE_UP 1 → 0" must be done by

external MCU.

- If the RF module is connected to Smart Devices (Android/ iOS), the pin

STATUS will be logic "1" to inform external MCU.

- Beacon

External

MCU

Module

Smart Phone

UART Beacon

Summary of content (3 pages)

PAGE 1
VEABT009 Module User's Manual 1. Features - On-chip low power microcontroller - Up to 1024 kB flash program memory - Up to 96 kB RAM data memory - On board crystal and PCB Antenna 2. Application - Mobile device accessories (Android/ iOS) - Wireless data communication - Remote sensors 3. Pin definition (from right to left) Pin No.
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or colocation with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC authorization.