Installation Instructions

DC POWER CEILING FAN WALL CONTROL MANUAL
ACTIVATING THE LEARNING PROCESS
1. After installation is complete, AC power is turned on
and SWITCH is at ON position within 30
seconds, press and hold the SET button for 3 seconds.
The receiver will make sound, Bi, once. This will
indicate the receiver has learned the ID that was
previously selected on the
transmitter. then the wall transmitter can control the
receiver.
2. If user cannot finish the setting within the 30
seconds time frame, the main power must be turned
off and re-started again. This will reset the unit. Repeat step 1 until the LEARNING feature is activated as
indicated.
WALL TRANSMITTER OPERATION
While the fan is on, Press this button to increasing fan speed (1~6speed).
While the fan is on,Press this button to decreasing fan speed (1~6 speed).
Press this button to turn the fan on or off.
Press this button to set fan wind direction up or down.
ON/OFF—Press this button and release instantly to turn on or off the light.
DIMMER—Press and hold to dim or brighten lights to the desired level and release. (Tungsten
bulb only)
AC POWER ON/OFF SWITCH, Slide to left to set power off, Slide to right to set power on.
LED indicator
，
When pressing remote button, the LED indicator on position 1 would be
on.When press fan speed button, the LED indicator on position 2~7 would be on( 1~6 speed).
Installing Wall Control (TRANSMITTER):
Remove wall plate, disconnect and remove the toggle switch
from wall junction box. Using the wire connectors,
make the electrical connections to the wall control
(transmitter) unit. Carefully push all connected wires
inside wall switch box. Secure wall control unit with
2 screws previously removed. Face plate could be locked
onto the transmitter.
TRANSMITTER
TR228A-A8106