User's Manual

LEARN

Installation of Transmitter Wall

Mount Holder with two screws

CEILING FAN REMOTE CONTROLLER

OPERATION AND INSTALLATION INSTRUCTIONS

(Please keep this instruction pamphlet.)

IMPORTANT POINTS TO REMEMBER:

1. Read and save these instructions.

2. Please note that all fixed wiring appliances should be installed by a qualified electrician.

3. The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall switch.

4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.

5. Install receiver into the ceiling fan canopy of the fan to ensure proper protection.

6. This unit is to be used for the control of ceiling fan and in an AC110V/120V 60Hz power supply only.

7. Do not install in damp locations or immerse into water. (For indoor use only.)

8. Do not pull on or cut leads shorter.

9. Do not drop or bump the unit.

10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place as this will

damage the transmitter. Dispose of used battery properly, keep the battery out of reach of children.

11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable (rheostat) wall

control.

INSTALLATION INSTRUCTIONS

1. Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pulling the “Pull Switch” after installation.

2. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy comes up to

cover the receiver and bracket.

LEARNING PROCESS

1. After installing the unit and power on, open battery cover (with batteries, DC1.5V/ AAA*2pcs,

installed), use a ball pen to press and hold the ”LEARN” key 1~3seconds. FAN will be turn off

and then FAN turn ON at medium speed, which indicate that learning process finished. Please

note that must press the “LEARNING KEY” within 30sensonds after power on. If just replace

batteries, no need to re-learn.

2. Please note that the transmitter can learn in multiple receiver, when doing learning process

please make sure not learn in other receiver.

FUNCTIONS OF TRANSMITTER

: Press and release immediately to turn on or off the fan.

: Press and release immediately to turn on or off the light.

TR95A

IMPORTANT

YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT

(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTRO

CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

PAGE 1
CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS (Please keep this instruction pamphlet.) IMPORTANT YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. IMPORTANT POINTS TO REMEMBER: 1.Read and save these instructions. 2.Please note that all fixed wiring appliances should be installed by a qualified electrician. 3.The supply to the remote control receiver should be connected through a mains switch, i.e.
PAGE 2
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.