User's Manual

ManualsBrandsChung's Electronic ManualsElectronicsWireless Weather Station

C8249E-PD10122M (WWVB) Size:105 x 130 (mm)

RADIO CONTROLLED

WIRELESS WEATHER STATION

Instruction Manual & Warranty

FCC Remarks

This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) This device must

accept any interference received, including interference that

may cause undesired operation.

Warning: Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which

can

be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or

more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for

help.

Summary of content (12 pages)

PAGE 1
C8249E-PD10122M (WWVB) Size:105 x 130 (mm) FCC Remarks This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 2
USD $9.
PAGE 3
TABLE OF CONTENCE REMOTE SENSOR Recommended operating range: -20°C to 55°C -4°F to 131°F Resolution: 0.1°C/1°F(above 0°C/32°F) 1°C/1°F(below 0°C/32°F) Humidity measuring range: 20%RH to 90%RH Operating range: 20%RH to 90%RH Resolution: 1%RH RF transmission frequency: 915MHz Remote sensor: 1 unit RF transmission range: maximum 100 meters Temperature sensing cycle: around 60-64 seconds POWER Main unit: 4.5V, use 3 x AA 1.5V alkaline battery Remote sensor: 3V, use 2 x AA 1.
PAGE 4
MAIN FEATURES: WEATHER STATION: 9 RESET 1 5 2 6 3 7 4 18 14 8 SPECIFICATION 16 MAIN UNIT 17 15 Recommended operating range: 0°C to 45°C 32°F to 113°F 10 11 Resolution: 1°C/°F(above 0°C/32°F) 1°C/°F(below 0°C/32°F) Humidity measuring range: 20%RH to 90%RH 12 RESET 13 Recommended operating range: 20%RH to 90%RH 19 18 14 16 17 15 2 Resolution: 1%RH1%RH Pressure measuring range: 850mb to 1050mb Pressure sampling cycle: 15 minutes Moon phase scanner range: from year 2000 to 2099
PAGE 5
NOTE: 1. MODE key: • Press it to switch between alarm1 and alarm2. • Press and hold it for 2 second to enter normal time setting. • In normal time setting, press it to step the setting items. 2. HISTORY key: • Press it to check the pressure records in the past 24 hours. 3. mb-hPa/inHg key: • Press it to switch between mb-hPa and inHg. • Press and hold it for 2 seconds to enter the “rel” and “abs” switch mode. 4. MAX/MIN key: • Press it to check the maximum/minimum temperature & humidity records.
PAGE 6
• Press and hold it for 3 seconds to receive the RC signal for reception testing. 7. UP key: • In setting mode, press it to increase the setting value. • Press it to select the channel 1, 2 or 3. 8. DOWN key: • In setting mode, press it to decrease the setting value. • In normal mode or alarm mode, press it switch between 12 and 24 hour format. 9. SNOOZE/LIGHT key: • Press it once to turn on the backlight for 5 seconds.
PAGE 7
Sunny Slightly cloudy Cloudy Rainy 14. Temperature & Moon phase window: • Shows the indoor and outdoor temperature, the max/min temperature records and current moon phase. 15. W eather forecast window: • Shows the weather forecast for coming 12 and 24 hours. ABOUT THE MOON PHASE The unit has 8 different moon phases. It will change according to the lunar calendar. 1. 2. 3. 4. 5. 6. 7. 8.
PAGE 8
3. RESET: • Press it to restart the transmitter and return all values to default values. 4. °C/°F: • Switches between Celsius and Fahrenheit. 5. BATTERY COMPARTMENT: • Accommodates 2 x AA size batteries. 6. BATTERY DOOR 7. WALL-MOUNTING HOLDER: • Use it to support the transmitter on the wall. 8. TABLE STAND: • Use it to stand the transmitter on the desktop. Max. temp.& humidity records Min. temp.
PAGE 9
VIEWING THE CHANNEL 2. The default channel is Channel 1. In normal time mode, press “UP” key for 3 seconds, with “beep” tone sound to view the channel 1 temperature and humidity. 3. HOW TO READ INDOOR AND OUTDOOR TEMPERATURE & HUMIDITY RECORD 4. Change the temperature unit to ºC for Celsius or ºF for Fahrenheit by pressing the “ºC/ºF” key. 5. Note: 6. 1. 2. 3. If no signal are received or the transmission is interfered, “—-” will appear on the LCD.
PAGE 10
NOTE: 1. 2. 1. The building material and the position of receiver and transmitter affect the effective range. So try various locations to obtain the best result. Place the units away from metal objects and electrical appliances to minimize the interference. Position the receiver and transmitter within the effective transmission range: 30 meters in usual circumstances. DAYLIGHT SAVINGS TIME (DST) The clock has been programmed to automatically switch when the daylight savings time is in effect.
PAGE 11
2. The dual-alarm (ALM1 & ALM2) design of this unit will provide you with more convenience, and you can set two-alarm time if needed. USING ALARM & TEMPERATURE PRE-ALARM FUNCTIONS 1. 2. Set the alarm time as described in the previous section. Press “ALARM ON/OFF” key once to turn on alarm1, press it twice to turn on alarm2, with the bell icon“ 1” (“ 2”)displays on the LCD. Press it again to turn off both alarm1 and alarm2, with the icons disappear. NOTE: 1. 2. 3.
PAGE 12
1. 2. 3. 4. 5. It is strongly recommended to start this clock at night and let the clock receive the signal automatically during midnight. Always place the unit away from interfering sources such as TV set, computer, etc. Avoid placing the unit on or next to metal plates. Closed area such as airport, basement, tower block or factory is not recommended. Do not start reception in moving articles such as vehicles or trains. 5. English SUN MON TUE 6.