C8243-PD08432M Size: 105 x 130 (mm) RADIO CONTROLLED WIRELESS WEATHER STATION MODEL C8243 USER’S INSTRUCTIONS
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
MAIN FEATURES: Dimension WEATHER STATION: Main unit: 76(W) x 142(H) x 29(D) mm Remote sensor: 40(W) x 128(H) x 23.5(D) mm This device complies with Part 15 of the FCC Rules. Operations is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. RESET Warning: 1. SNOOZE / LIGHT: - Press it once to turn on the backlight for 5 seconds.
RF transmission frequency: 433MHz No. of remote unit: up to 3 units RF transmission range: maximum 30 meters Temperature sensing cycle: around 60 ~ 64 seconds Moon phase scanner range: from year 2000 to 2050 Radio controlled signal: WWVB/DCF/MSF Power Main unit: 4.5V, use 3 x AA 1.5V alkaline battery Remote sensor: 3V, use 2 x AA 1.5V alkaline battery Weight Main unit: 225gm Remote sensor: 106gm 18 4.
- In alarm time mode, press it to turn on/off the Alarm and Snooze. 10. TIME: - In normal time mode or alarm time mode, press and hold it for 2 seconds to enter the normal time setting mode. 11. YEAR: - Press it to switch between Date/Month and Year display. 12. ALARM: - Press it to stop the current alarm when the bell is ringing and turn off the snooze function. - Press it to switch between Date/Month and alarm time mode. - In normal time mode, press it to enter the alarm time mode.
transmitter into the stand on the wall. Besides, you can place it on the desktop by its table stand. For the receiver, place the screw on the desired wall and hang the receiver by the recessed hole at the back of the clock or just simply place it on the desktop by the table stand. You can use the table stand according to the following steps: 1. Slide the table stand downwards to separate it from the knob. 2. Revolve the separated table stand outwards for 90 degrees. 3.
4. BATTERY COMPARTMENT: - Accommodates 2 AA size batteries. 5. BATTERY DOOR: 6. WALL-MOUNTING HOLDER: - Use it to support the transmitter on the wall. BATTERY REPLACEMENT When the LCD becomes dim, replace with 3 AA size batteries at once; while if the low battery indicator “ ” displays in the Outdoor Temperature window, it indicates that the battery power of the transmitter is not enough, and you should replace with 2 AA size batteries at once. Transmitter’s low battery indicator 7.
3. After several trials in vain, please reset the clock thoroughly. Try out where your multifunctional alarm clock receives the signals best. WEATHER STATION: 1. CHECKING AND DELETING MAX. /MIN. TEMPERATURE REOCRDS 1. 2. Press the “MAX/MIN” key once to check the maximum temperature record. Press it twice to check the minimum record. Press it again to exit. Press and hold the “MAX/MIN” key for 3 seconds to delete the maximum and minimum temperature records. MAX.temperature record MIN.
4. NOTE: 1. 2. 3. 4. 5. 6. The accuracy of a general pressure-based weather forecast is about 70% to 75%. The weather forecast is meant for next 12 to 24 hours. It may not necessarily reflect the current situation. The “Sunny” icon can only appear from 6 AM to 8 PM; while if the weather is Cloudy/Rainy/Stormy during this period, the “Sunny” icon may not appear.
ALARM AND SNOOZE SETTING RECEPTION OF RADIO CONTROLLED TIME SIGNAL 1. The time and date are radio-controlled. The current time and date are automatically synchronized with the time signal transmitted from Germany (DCF 77) / UK (MSF) / USA (WWVB) provided the device is within about 1500 km range of the transmitter. When used for the first time (after inserting the batteries or pressing the “RESET” key), the clock starts receiving the time signals and the reception display flashes. 2. 3. 4. 5. 6.
5. Do not start reception on moving articles such as vehicles or trains. DAYLIGHT SAVINGS TIME (DST) The clock has been programmed automatically to switch when the daylight savings time is in effect. Your clock will show “DST” during the summer. TIME ZONE SETTING (WWVB version only) The default time zone is PACIFIC time zone. If your location is not in the Pacific time zone, set the time zone as follows: 1. In normal time mode, press the “ALARM” key to enter the alarm time mode. 2.