User's Manual

ManualsBrandsChuango Security Technology ManualsElectronicsPet-Immune PIR Motion Detector

Table Of Contents

Pet-Immune Function Illustration

MD9100

User Manual

Introduction

MD9100 motion detector adopts unique design with dual

infrared sensors and intelligent analysis algorithm which

effectively identify interference signal from body movement

signals. It can reduce false alarm rate caused by pets under

20kgs or other interfering objects. The detector is suitable for

lobby, hallway detection with a detective range of 0-9 m at front.

With low power feedback function, the users will get SMS alert

or push message for low battery if the detector has been

connected to a GSM or Wi-Fi alarm system.

Product Overview

1. Detection window

2. Status indicator

3. Test button

4. Double-sided tape

stick place

5. Bracket slot

Detection Range

Infrared sensor: It detects the infrared rays released by human

body motion, please don’t touch the surface and always keep it

clean.

Tamper switch: Once the case is opened in working mode, the

tamper switch is triggered and then generates an alarm signal.

Infrared sensor

AA 1 . 5V LR6

Status indicator

Pet-Immune PIR

Motion Detector

Tamper switch

Blinks twice

Blinks once every 3 seconds

Testing mode is finished, the

detector enters power-saving mode

Low battery, please replace the

battery as soon as possible

Status Indication

Display

Meaning

Blinks continuously

Blinks once

Self testing

Intrusion detected

Working Mode

Testing Mode

Press the test button, the detector enters testing mode and detects

once every 10 seconds. After 3 minutes, the status indicator blinks

twice, and the detector switches to power saving mode.

Side view

IMPORTANT: If you keep a pet at home, make sure the detector is installed

at the upright position to achieve pet-immune function.

3m 6m 9m

Top view

Power Saving Mode

If the PIR motion detector detects movements twice in 3 minutes, it

automatically goes into a sleep state. If there is no movement

detected in next 3 minutes, it will switch from sleep state to arm.

During the 3 minutes, the detector won’t be active and send any

signals to the control panel. As long as there is a movement

detected within 3 minutes, the duration of power saving mode will

be extended.

Sleep after detecting human movement twice.

Case 2:

Press the test button and then arm.

3 minutes later

No human movement within 3 minutes

Switch from sleep to arm.

Case 1:

Initial start and then arm.

Summary of content (2 pages)

PAGE 1
Status Indication Pet-Immune PIR Motion Detector Pet-Immune Function Illustration Meaning Display Blinks continuously Self testing Blinks once Intrusion detected Blinks twice Testing mode is finished, the detector enters power-saving mode Blinks once every 3 seconds Low battery, please replace the battery as soon as possible 2m MD9100 9m 1m User Manual 2m IMPORTANT: If you keep a pet at home, make sure the detector is installed at the upright position to achieve pet-immune function.
PAGE 2
Pairing to Control Panel Step 1: The ideal mounting height of the motion detector is 2 FCC STATEMENT meters from the floor. It is suggested to mount it at the corner of 1.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: the wall or just stick it to the wall by using the supplied 3M sticker. Control panel enters pairing state Make the control panel in pairing state.