KP-20 Security Keypad EN © 2017 SMANOS HOLDING LTD. All Rights Reserved. Printed in China Ver: KP-20-UM-ML-V1.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Introduction This KP-20 Security Keypad is a wireless device with four nonnumeric keys that can be used to Arm, Disarm or Home Arm K1 system . Product Overview Rear View Front View ;6 ɑ Rotatable Keypad Ring ;6 ɑ Pairing to the K1 Hub This Keypad needs to be paired (other than the KP-20 that is included with the K1 System Kit) to the K1 Hub first before use.
;6 ɑ LED Indication Steady Red: System Armed Steady Blue: System in Home Mode Steady Green: System Disarmed Blink once every 3 seconds: Low battery, please change the battery. Tamper Switch Anti-tampering protection ensures that any attempts to move the Keypad off the Back Cover results in an alarm and push notification. Non-numeric Keys How to Use After Pairing Make sure the UP mark on the Back Cover points up before putting the Keypad on a flat surface.
Disarm Rotate the Keypad Ring to the left, and then enter the Keypad password (if you have not changed the default password, Press the left top key 6 times). The indicators will turn to Green. Start to install the Keypad with by supplied double-sided tape or screws. Notice: Removing the Back Cover off of the KP-20 will result in an alarm; you can disarm the alarm and continue the installation.