DS-20 Door/Window Sensor EN © 2017 SMANOS HOLDING LTD. All Rights Reserved. Printed in China Ver: DS-20-UM-ML-V1.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Introduction The DS-20 Door/Window Sensor detects the open/close status of a door or window being protected. It can be installed on a door/door frame, window/window frame or any other object that can be opened/closed and needs detection. Product Overview Front View Rear View LED Indicator Inside View Tamper Switch Tell us what you have found to monitor with your DS-20 or find ideas on our facebook page at www.facebook.com/smanos.
Installation There are aligning marks on the sides of the transmitter and magnet; make sure the marks face each other and within the range of 1 cm (0.4”). Specifications Place the sensor near the location that needs protection. Set the K1 system to Test Mode, and then trigger the Door Sensor by separating the Magnet and Transmitter. The K1 Hub will sound 3 beeps to confirm the connection and range with K1 Hub is good. Then start to install the sensor with the supplied double-sided tapes.
Avis d’Industrie Canada Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.