User's Manual

DWC-100
Ver: DWC-100/EN-1210-2.0
Operation Manual
Wireless Door/Window Contact
The DWC-100 is a Door/Window Contact that can be
installed on doors, windows, and any other objects that open
and close. The sensor transmits signals to the control panel
when a magnet mounted near the sensor is moved away.
External input for wired accessory is available at the N/C
interface. The tamper protection ensures that sabotage
attempts to move the contact will result in an alarm activation.
Features
Appearance
Transmitter Magnet
LED indicator
LED Indication
LED flashes once: Door/window is opened and
transmitter sends signal to the control panel.
AA 1.5V LR6
PCB Layout
Tamper switch
Zone setup
Installation & Notice
Open the case and remove the battery activation strip.
Mount the sensor on the door frame and the magnet on the door.
Make sure the magnet is on the right side of the transmitter
Place the transmitter in the desired location, mount the
magnet no more than 1cm away from the transmitter and secure
the transmitter and magnet with double-sided tapes or screws.
Avoid mounting sensors in areas with a large quantity of metal
or electrical wiring, such as a furnace or utility room.
Specifications
-10°C~55°C
71 x 34 x 17.5mm
51 x 12 x 13.5mm
DC 1.5V (AA 1.5V LR6 Battery x 1pc)
≤ 30uA
≤ 40mA
Power supply
Static current
Alarm current
Transmitting distance
Radio frequency
Housing material
ABS plastic
Operating temperature
Transmitter dimensions (LxWxH)
Magnet dimensions (LxWxH)
Relative humidity
≤80% (non-condensing)
≤80m (in open area)
FCC Statement
315.8599MHz
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.