User Manual

ManualsBrandsChromagic Technologies ManualsElectronicsSmall Door Sensor

Mini Door/Window Contact Detector (HSM01)

Installation and Operating Instructions

These instructions should be read in conjunction

with your System Installation and Operating

Manual and be retained for future reference.

The Door/Window contact detector is compatible with a

series of Everspring control panels – SC801, SC811,

SC821, or IP Gateway HSC04….,operating at 868

MHz or 923 MHz only.

The Door/Window contact detector consists of two

parts; a Detector and a Magnet. They are designed to

be fitted to doors or windows with the Magnet mounted

on the opening part and the Detector mounted on the

fixed frame. Opening the protected door/window will

remove the magnetic field, trigger the Detector and

generate an alarm condition, (if the system is armed).

The Detector is powered by 1 pieces of 3V CR2450

battery which under normal conditions will have typical

life in excess of 3 years. Under normal battery

conditions with tamper switch being pressed, the LED

on the Detector will not illuminate when the Detector is

triggered. However, under low battery conditions this

LED will be illuminated when the detector is triggered.

When this occurs the battery should be replaced as

soon as possible.

CHOOSING A MOUNTING LOCATION

The Door/Window Contact is suitable for mounting in

dry interior locations only.

Decide which doors/windows are to be protected by

Door/Window Contact, (usually the front and back

doors as a minimum will have Door/Window Contact

fitted). Additional detectors may also be fitted where

required to other vulnerable doors or windows, (e.g.

garage, patio/conservatory doors etc).

Note: Take care when fixing the Detector to a metal

frame, or mounting within 1m of metalwork (i.e.

radiators, water pipes, etc) as this could affect the radio

range of the device. If required, it may be necessary

to space the magnet and detector away from the metal

surface using a plastic or wooden spacer to achieve

the necessary radio range.

INSTALLING THE DOOR/WINDOW

CONTACTS

Ensure that the system properly powered.

Factory default built in a CR2450 battery inside the

detector and uses a Mylar film to isolate battery from

electric circuit of the detector. Remove the battery

Mylar film when ready to let the detector work.

If there is no battery inside the detector or need to

replace a new battery please insert the battery in 45°

angle as below figure

FIX AND TEST THE DOOR/WINDOW CONTACTS

1. Using the adhesive tape to fit detector on the door

or window.

2. Fit the Magnet to the moving part of the

door/window opposite the Detector using the

adhesive tape.

3. Ensure that the parallel gap between the Magnet

and Detector is less than 20mm and that the

matching line on the Magnet is pointing towards

and aligned with the line on the Detector. An alarm

Summary of content (3 pages)

PAGE 1
Mini Door/Window Contact Detector (HSM01) Installation and Operating Instructions These instructions should be read in conjunction with your System Installation and Operating Manual and be retained for future reference. Note: Take care when fixing the Detector to a metal frame, or mounting within 1m of metalwork (i.e. radiators, water pipes, etc) as this could affect the radio range of the device.
PAGE 2
detector, the LED will illuminate for approx. 1 second to indicate that the Detector has been triggered. 3. If connected, operate the wired Magnetic Contact. As the contact is opened the LED on the Detector should illuminate for 1 second to indicate that it has been triggered. 4. When the tamper switch is pressed, the Detector enters the normal mode. 5.
PAGE 3
When replacing old appliances with new once, the retailer is legally obligated to take back your old appliance for disposal at least for free of charge. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.