User`s manual

ManualsBrandsChristie ManualsProjector103-013100-01

LX1500 Lamp/Filter Replacement Instruction Sheet 1 of 4

020-000013-01 Rev. 1 (09/07)

LX1500 Lamp/Filter Replacement

Instruction Sheet

INTRODUCTION

These instructions outline the details for Lamp and Filter replacement in the LX1500 projector (Model

No. 103-013100-01). The lamp is located at the rear of the projector (below the input panel) and can be

accessed by removing the lamp door. Use only a Christie approved Lamp and Filter Kit for your

specific projector model.

KITS REQUIRED

003-120338-01 (Replacement Lamp Type No.: POA-LMP109)

003-001733-01 (Replacement Air Filter)

INSTRUCTIONS

This Projector is equipped with 4 Projection Lamps to ensure brighter image and those lamps are

controlled by the Lamp Management Function. The Lamp Management Function detects the status of

all lamps and shows the status on screen or on the LAMP REPLACE indicator. This function also

automatically controls the Lamp Mode when any of lamps is out for the end of life or malfunctions.

Refer to the User’s Manual for complete details on Lamp Management.

LAMP REPLACEMENT PROCEDURE

When the projection lamp of the projector reaches its end of life, the Lamp Replacement icon

appears on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one

promptly. The timing when the LAMP REPLACE indicator should light is dependent on the lamp

mode.

DANGER

Disconnect all power sources to the projector before opening lamp cover.

Summary of content (4 pages)

PAGE 1
LX1500 Lamp/Filter Replacement Instruction Sheet INTRODUCTION These instructions outline the details for Lamp and Filter replacement in the LX1500 projector (Model No. 103-013100-01). The lamp is located at the rear of the projector (below the input panel) and can be accessed by removing the lamp door. Use only a Christie approved Lamp and Filter Kit for your specific projector model. KITS REQUIRED 003-120338-01 (Replacement Lamp Type No.
PAGE 2
WARNING Allow a projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of a projector can become very hot. DANGER Do not drop the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury. NOTICE: For continued safety, replace with a lamp assembly of the same type. 1. Check the number of lamp to be replaced on the Lamp Status Display. 2. Turn off the projector and unplug the AC Power Cord. Let the projector cool for at least 45 minutes. 3.
PAGE 3
1. Press the MENU button to display the On-Screen Menu. Use the buttons to move the red frame pointer to the Setting Menu icon 2. Use the buttons to move the red frame pointer to Lamp counter and then press the SELECT button. A dialog box appears. Select a lamp and the “Lamp replacement counter Reset?” appears. Select [Yes] to continue. 3. Another confirmation dialog box appears and select [Yes] to reset the Lamp counter.
PAGE 4
RESETTING THE FILTER COUNTER Be sure to reset the Filter counter after cleaning or replacing the filter. 1. Press the MENU button to display the OnScreen Menu. Use the buttons to move the red frame pointer to the Setting Menu icon. 2. Use the buttons to move the red frame pointer to Filter counter and then press the SELECT button. A dialog box appears showing the Used Time option you can scroll to view the remaining Time options. Use the buttons to select Used time. 3.