Product Manual

Using a stud nder attach bottom

section of True Plumb to a stud.

Note: When mounting to a concrete

wall use a 1/4” masonry bit and

expanders provided.

Use a level and mount the bottom

section with two screws provided.

- Next (this will probably take

two people) Attach the top sec-

tion so there is 7 feet between the

bottom of the U-joint and the top

of the adjusting plate on bottom

section. Level and mount with

two screws provided.

TRUE PLUMB

Instructions for

16TPL2000

16TPL2000 xed height True Plumb

This True Plumb can be used for both xed height 2 meter pole as well as regular prism pole.

Note: Do not mount next to a light switch or electric outlets.

P.O. Box 516

Ross, OH 45061

PAGE 1
TRUE PLUMB Instructions for 16TPL2000 16TPL2000 fixed height True Plumb This True Plumb can be used for both fixed height 2 meter pole as well as regular prism pole. Note: Do not mount next to a light switch or electric outlets. 1- Using a stud finder attach bottom section of True Plumb to a stud. Note: When mounting to a concrete wall use a 1/4” masonry bit and expanders provided. 2- Use a level and mount the bottom section with two screws provided.
PAGE 2
TRUE PLUMB Calibration: 1. 1. Screw in white plastic bolt “Adapter” into bottom of U-joint. 2. Place the spare plumb bob tip provided upside down in bottom adjust plate. 3. Using a 12 ft. gammon reel hook into U-joint adaptor and let it hang above the upside down plumb bob tip so it is almost touching. 4. Loosen nut on adjusting plate with a 1/2” wrench and move plate so it lines up with plumb bob tip. Note: you can also lower it into the hole until you get equal light around it. (Picture#4) 5.