Quick Start Guide

Connecting speakers to ULTIMA 4.0
The binding posts on ULTIMA are designed to accommodate bare wire,
spade connectors and banana plugs.
Banana plugs: can be inserted into the middle of the binding posts,
as shown below, to achieve a reliable connection. Align a banana plug
with the binding post and push the connector confidently until it stops.
You must pay attention to the polarity, making sure that a positive
connection on ULTIMA matches the positive connection on the wire
and speaker. You must also pay careful attention to the left and right
channels.
Chord Electronics
ULTIMA | Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
[e-mail]
chordelectronics.co.uk
Quickstart Manual
Introduction 1.0
Welcome to the ULTIMA Quickstart Guide. This shortened guide is
supplementary to the main manual which should be referred to for full
safety and operational information.
Please note, more information on any of these topics is listed within the
full manual found under the product page:
chordelectronics.co.uk/product/ultima
Warranty 1.1
The ULTIMA comes with a comprehensive 5-year warranty. To activate
this warranty, please register your device via the Chord Electronics
website:
chordelectronics.co.uk/register-product
Connecting ULTIMA to a preamp 3.0
First, ensure that ULTIMA, and any connecting equipment, is turned o.
Any volume controls/attenuators should also be at their lowest setting.
Both Ultima mono amplifiers need to be connected the same way, RCA
or XLR. Connect the preamp output to each Ultima mono left input
denoted by a black band round the RCA input. Your connected device
must have preamplifier capabilities to prevent damage to connected
equipment.
Input
Please ensure there is sucient ventilation around ULTIMA at all times.
Avoid placing ULTIMA in enclosed spaces, on soft surfaces, near
sources of heat and never cover its ventilation holes. For optimum
operation and ventilation leave some space around the unit.
Placement 2.0