Quick Start Guide

Connecting speakers to TToby 4.0
The binding posts on TToby are designed to accommodate bare wire,
spade connectors and banana plugs.
Banana plugs: can be inserted into the middle of the binding posts,
as shown below, to achieve a reliable connection. Align a banana
plug with the binding post and push the connector confidently until
it stops. You must pay attention to the polarity, making sure that a
positive connection on TToby matches the positive connection on the
wire and speaker. You must also pay careful attention to the left and
right channels.
Chord Electronics
TToby | Quickstart Manual
The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom
[e-mail]
chordelectronics.co.uk
Quickstart Manual
Introduction 1.0
Welcome to the TToby Quickstart Guide. This shortened guide is
supplementary to the main manual which should be referred to for full
safety and operational information.
Please note, more information on any of these topics is listed within the
full manual found under the product page:
chordelectronics.co.uk/product/ttoby
Warranty 1.1
The TToby comes with a comprehensive 3-year warranty. To activate
this warranty, please register your device via the Chord Electronics
website:
chordelectronics.co.uk/register-product
Connecting TToby to a preamp 3.0
First, ensure that TToby, is turned o. Ensuring your pre amplifier is
turned o and the volume is set to minimum, connect the XLR or RCA
audio outputs from the partnering preamp to the TToby corresponding
XLR or RCA inputs, paying careful attention to the left and right
channels.
Input Input
Although TToby is compact, it features a highly advanced Class
A/B sliding bias design which generates heat. Please ensure there is
sucient ventilation around TToby at all times. Avoid placing TToby
in enclosed spaces, on soft surfaces, near sources of heat and never
cover its ventilation holes. For optimum operation and ventilation leave
some space around the unit.
Placement 2.0