Quick Start Guide

ManualsBrandsChord ManualsAudioElectronics Hugo TT 2 DAC, Preamplifier & Headphone Amplifier

Connecting the power to Hugo TT 2 5.0

Connecting to a Hugo M Scaler from the Hugo TT 2 3.0

Connect only the supplied power supply to the DC 15V input of Hugo

TT 2. Once connected to the Hugo TT 2, it may start automatically.

Please make sure none of your other devices are switched on at this

point.

If using Hugo M Scaler you should use the Dual BNC cables provided

to connect it with the Hugo TT 2. By using M Scaler all of your inputs

must now be connected to M Scaler and not TT 2 - refer to the M Scaler

User Manual.

OPT OUT

S/PDIF

DUAL BNC OUT

Chord Electronics

Hugo TT 2 | Quickstart Manual

The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom

info@chordelectronics.co.uk

chordelectronics.co.uk

Quickstart Manual

Introduction 1.0

Welcome to the Hugo TT 2 Quickstart Guide. This shortened guide is

supplementary to the main manual which should be referred to for full

safety and operational information.

Please note, more information on any of these topics is listed within the

full manual found under the product page:

chordelectronics.co.uk/product/hugott2

Warranty 1.1

The Hugo TT 2 comes with a comprehensive 3-year warranty. To

activate this warranty, please register your device via the Chord

Electronics website:

chordelectronics.co.uk/register-product

Note: please do not use a third-party charger with the Hugo TT 2 as it

voids any warranty

Connecting your source to Hugo TT 2 2.0

In order to use the Hugo TT 2, you must connect your source to any

input of the device. You can connect multiple sources if you wish and

select between them later from within the menu.

Please note that if you are using the USB input with a MAC/Linux

device you will not need a driver but if you are connecting a Windows

device it will need a driver from the Hugo TT 2 section of our website:

chordelectronics.co.uk/product/hugott2

Input

To connect an ampliﬁer, such as TToby, to the Hugo TT 2, you should

connect the outputs of TT 2 to the inputs of your ampliﬁer.

Connecting an ampliﬁer to Hugo TT 2 4.0

Output

Summary of content (2 pages)

PAGE 1
Chord Electronics Hugo TT 2 | Quickstart Manual The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom info@chordelectronics.co.uk chordelectronics.co.uk Quickstart Manual Introduction 1.0 Welcome to the Hugo TT 2 Quickstart Guide. This shortened guide is supplementary to the main manual which should be referred to for full safety and operational information. Connecting to a Hugo M Scaler from the Hugo TT 2 3.
PAGE 2
Chord Electronics Hugo TT 2 | Quickstart Manual The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom info@chordelectronics.co.uk chordelectronics.co.uk Quickstart Manual Switch on the Hugo TT 2 6.0 Once all inputs are connected, you should not yet initiate playback. Turn on the Hugo TT 2 by pressing the power button, the device will run its start up sequence before it is ready to be used. The Hugo TT 2 will start up in DAC mode, learn more about this mode below (8.0).