Owners Manual

Operation
3.0
Chord Electronics
Anni | Manual
_
Chord Electronics
Product Communication | English
_
The Pumphouse Farleigh Lane,
East Farleigh, Maidstone
ME16 9NB United Kingdon
[e-mail]
chordelectronics.co.uk
Anni
Manual
_
V.1
Power output 10 W 8 ohms
THD 0.02 %
Signal to noise -92 dB
Noise floor -110 dB
Frequency response 5 Hz-60 kHz
chordelectronics.co.uk
_
Gain
Anni benefits from a two-stage (high and low) gain function on the
loudspeaker outputs (only) to suit a wide range of partnering speakers.
Press the gain button to alternate between low (blue) and high (red) gain
modes, allowing 3 seconds to switch between modes.
When using either of the headphone outputs, Anni is automatically
switched to low gain mode. If when inserting headphones Anni was
previously set to high gain (red) the gain sphere will show purple, before
reverting back to red when the headphones are removed. If low gain (blue)
was previously selected, the gain sphere will remain blue and continue to
display blue when the headphones are disconnected.
If using Anni with Qutest, ensure Qutest’s output voltage is set no higher
than 2 V. The Qutest manual describes how to set output voltage.
Placement
Anni benefits from extensive casework ventilation and a cooling fan for
demanding environments. Always ensure Anni is used in a well-ventilated
setting, away from direct sunlight and heat sources, and has sucient
space around the unit.
Chord Electronics’ Qutest Stand System (available separately) has been
designed to perfectly house Anni. Otherwise, care should be taken not to
stack other units on Anni.
Support
If you need support, in the first instance, please contact your supplying
retailer who will be best placed to assist you. If you need additional help
beyond that of your retailer, please visit our support page: chordelectronics.
co.uk/get-support
Specifications