Instruction for remote control of gasoline generator
Indicator light Start Button Stop Button Remote control case Sliding cover Key chain Appearance of remote control (Front)
Screw Hole Screw Hole Screw Hole Appearance of remote control (Rear)
Mounting Mainframe hole position housing Conductor interface Conductor interface Machine Drawing (Front)
Mainframe housing Mounting position hole Mounting position hole Appearance of main engine (rear) Product description: The remote control Shell is made of imported high-quality ABS flame-retardant material, the metal outer ring can prevent from being damaged, the stainless steel panel and the button give a very good texture, with a safety push cover to avoid being accidentally touched and triggered, it's safe to use. It uses a surface acoustic resonator and a high-power RF circuit.
Performance description: 一、 APPEARANCE: 1. Plastic Shell surface should be free of cracks, fading and permanent stains. 2. The enclosure shall have sufficient mechanical strength and shall not be permanently deformed or damaged by the pressure test. 二、 Technical indicators: 1. Environmental Adaptability: The product should work well under the condition of temperature-20 °C —— + 70 °C。 2. P2P data transfer。 3. Data Wireless Transmission Distance: 80M (open and barrier free) 4.
Step 2: Press the 'start' button on the remote control board to drive the generator to run normally. Step 3: Close the remote protection slide Through the above steps, the generator can start normally 二、 enerator failure (when the generator is in normal operation) Step 1: Remove the remote protection slide cover Step 2: press the 'stop 'button on the remote control board, the generator starts to stop. The motor can not start again during the shutdown. Step 3: Close the remote protection slide.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
