User's Manual
- 1 -
USER'S MANUAL
1. On/off operation
1.1. Place all disc extensions on the powered charging base, and then the extension number
LED will light up to complete the boot operation.
1.2. Place all the disc extensions on the powered base, and then input "0" from the keyboard
and short press the 【Call】key, and then the extension number LED light will go out to complete the
shutdown operation.
2. Function setting operation flow
2.1 Short press the 【Function】 key to enter the password verification interface "_._._._.",
enter the four-digit password to enter the mode selection interface, the default screen flashes "F1".
2.2. Short press【Up/Down】key or number to select function mode "F0-F9".
2.3. Short press【Enter】key to enter the setting mode.
2.4. Short press 【Return】 key to return to mode selection, the screen displays "F0-F9".
2.5. Short press the【Function】key to exit the setting mode, the standby screen displays "----".
Note: Please complete other function settings (such as reminder duration, flash frequency,
vibration frequency, etc.) before setting the extension number. After the function is changed, the
extension number must be reset to be valid!
3. Menu function operation process
3.1.【F0】Extension reminder time setting
Enter the setting mode, enter "00-99" seconds ("00" means unlimited time), short press the
【Confirm】key to save, and the extension will be valid after resetting the number.
3.2.【F1】Extension number setting
3.2.1. Enter the setting mode, enter the extension number "1-9999" and short press the
【Call】 key, the keyboard screen starts to flash at this time, immediately remove the extension
and place it directly above the infrared communication position of the keyboard (the left side of
the LED screen) 10 Induction is performed at the centimeter, and after the extension beeps
twice and flashes, it indicates that the setting is successful.
3.2.2. Then you can re-enter the number to set the next extension, until all the extensions