User Manual
CONTENTS Features........................................................................................... 01 Buttons and functions.................................................................... 01 LCD display..................................................................................... 02 Battery installation......................................................................... 02 Battery display and low battery warning...................................... 02 Use the charger to charge...
Features • LCD backlight display • 22 channels • 121 subtone codes (38 analog, 83 digital) • Busy lock • Headphone jack • 10 optional calling tones •(VOX)Vox function • High and low power • Roger beep • Companding function • Battery display • Scanning function • Keypad lock • Voice prompt • Power saving function • Low battery alarm • Keypad tones • TOT function Buttons and functions LCD display Antenna Power on/off and scan switch Earpiece and programme jack PTT Type-C charging port Down/calling tone
LCD display Vox Scan High power Lock Volume mute Status(tx/rx) Battery power Battery installation 1) Battery: Li-ion battery. 2) Press the battery upwards to remove the battery. 3) Put the battery into the battery slot, pay attention to install the battery strictly according to the positive + negative-instructions in the slot, and press down firmly. 4) Reinstall the battery. Battery display and low battery warning The battery icon shows the battery level, from full display to space (0 battery).
Use the charger to charge 1) Make sure the radio is closed. 2) Insert the Type-c charging plug into the jack of the radio with the rechargeable battery, and plug the other end of the charger into the power socket on the wall. 3) During the charging process, the battery symbol is displayed on the mobile to indicate the charging state. When the battery is fully charged, the battery symbol stops.
key to skip to the next menu setting. 4) The radio can only be communicated when the radio is set to the same channel, and the radio is clear and no noise. Tone code selection The distribution of tone codes can reduce the mutual interference between radios, but the radios with different tone codes cannot make calls. Each channel has 0 to 121 tone codes, so that your communication is more confidential.
Scan function In the standby state of the radio mode, press the ◎ key 6 times, and "SC" will be displayed on the screen. Press ˂ or ˃ key to select on and off Press【PTT】key to save the current settings and exit the menu to start The scanning function of the radio scans the effective signal channels, which can easily scan 22 channels Note: When the scan menu setting is selected as OF, the scan function will be invalid when you press the [Power Switch/Scan] key.
1) Press and hold the 【◎ 】key until the icon ( ) appears to enter the keyboard lock state. 2) Long press and hold the 【◎ 】key until the icon ( ) disappears to exit the keyboard lock state. Note: When the keyboard is locked, except for pressing the [PTT] and [Power Switch/Scan] keys, any key press will sound a key failure tone. Power saving function The radio has a unique function to extend the service life of the battery.
Specification Table GENERAL Frequency Rang Channel capacity Working Voltage Antenna impedance Step frequency TRANSMITTER Output power Adjacent channel power TX current Spurious radiation Modulation limited RECEIVER RF sensitivity Opening sensitivity Audio output Receive current Waiting current 462.5500~467.7125MHz 22 CH 3.7 V 50Ω 12.5KHz 2 W / 0.5 W ≥60dB ≤1.35A ≤7.5µW ≤2.5kH ≤0.25uV ≤0.20uV ≥300mW ≤410 mA ≤20mA Frequency table(FRS) Channel 1 2 3 4 5 6 7 8 9 10 11 Frequency 462.5625MHz 462.5875MHz 462.
Weather channel and frequency Channel WX1 WX2 WX3 WX4 WX5 WX6 Frequency 162.550MHz 162.400MHz 162.475MHz 162.425MHz 162.450MHz 162.500MHz Channel WX7 WX8 WX9 WX10 WX11 Frequency 162.525MHz 161.650MHz 161.775MHz 161.750MHz 162.
Guarantee Model Number: Serial Number: Purchasing Date: Dealer: Telephone: User’s Name: Telephone: Country: Address: Post Code: Email: Remarks: Please cut along with this line 1.This guarantee card should be kept by the user, no replacement if lost. 2.Most new products carry a two-year manufacturer’s warranty from the date of purchase. Further details, pls read http://www.retevis.com/after-sale/ 3.The user can get warranty and after-sales service as below: • Contact the seller where you buy.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to part 15 of the FCC Rules.