INSTALLATION INSTRUCTIONS Gangable Racks Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description NG1F28-36-44
NG1F28-36-44 Installation Instructions DISCLAIMER damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided. Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete.
Installation Instructions NG1F28-36-44 DIMENSIONS MODEL WEIGHT CAPACITY Lbs (kg) RACKING HEIGHT UNITS NG1F2828 NG1F2833 NG1F3628 2500 (1134) 2500 (1134) 28 28 OVERALL USABLE WIDTH (C) HEIGHT (D) DEPTH (A) DEPTH (B) Inches (mm) Inches (mm) Inches (mm) Inches (mm) 28 (711) 33 (838) 24.5 (622) 29.5 (749) 23.3 (592) 23.
NG1F28-36-44 Installation Instructions TOOLS REQUIRED FOR INSTALLATION 9/16" PARTS A (1) [G1 rack] B (8) 3/8-16 x 5/8" C (8) 3/8" (NG1F2828 shown) 4
Installation Instructions NG1F28-36-44 INTRODUCTION The G1 Series racks may be configured with optional accessories (not included) such as doors, side panels, levelers, casters, fan panels, etc. All accessory installation instructions accompany the accessories.
NG1F28-36-44 Installation Instructions Side Panels 3. If desired, add optional side panels (not included) to the rack following instructions included with the panel(s). Remove and save nut from the grounding lug on side rail. (See Figure 6) 4. Attach grounding wire from door to the grounding lug. (See Figure 6) 5. Replace and tighten nut onto grounding lug. (See Figure 6) Doors Add optional door(s) (not included) to the rack following instructions included with the door(s).
Installation Instructions NG1F28-36-44 6. Change optional logo panel by removing and saving 4 nuts from studs at inside top of front. (See Figure 7) 7. Remove blank panel and replace with optional personalized logo panel (not included). (See Figure 7) 8. Replace and tighten four nuts removed in Step 6. (front view of rack) logo panel 6 8 Figure 7 LOADING THE RACK NOTE: The alignment panels shipped with the racks are optional. They may be removed to facilitate loading of the racks.
NG1F28-36-44 Installation Instructions USA/International Europe Chief Manufacturing, a products division of Milestone AV Technologies 8821-002028 Rev00 2011 Milestone AV Technologies, a Duchossois Group Company www.chiefmfg.com 03/11 Asia Pacific A P F A P F A 8401 Eagle Creek Parkway, Savage, MN 55378 800.582.6480 / 952.894.6280 877.894.6918 / 952.894.6918 Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands +31 (0)40 2668620 +31 (0)40 2668615 Office No.