Operation manual DB-2400 Digital Belt-pack Transmitter CHIAYO ELECTRONICS CO.,LTD.
DB-2400 Digital Belt-pack Transmitter Parts and functions Antenna Setting button MENU Menu button SET LCD Cover release button High-impedance gain control Channel sync button Low-impedance gain control Battery compartment Battery power LED Power switch Audio input connector Charging contacts Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Instructions FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 0.
DB-2400 Digital Belt-pack Transmitter Changing CHANNEL / FREQUENCY 1 Press-release MENU button until the CHANNEL-FREQUENCY page appears. C H: 07 9 2480 MHz 2 Press and hold SET button until the channel number flashes to denote readiness for setting. CH :0 79 2480 MHz 3 Press-release SET (UP) or MENU (DOWN) button to select a new channel. C H: 07 6 2477 MHz 4 After a channel is chosen, wait about 3 seconds to store the setting.
Instructions Channel synchronizing of the receiver and transmitter 1 Open the cover and then press and hold the synchronizing button until LINK flashes on the LCD. CH :0 00 LINK 2 Press and hold the receiver’s SYNC button until the frequency icon FREQ appears. After successful channel synchronizing, this icon will disappear automatically. CH SYNC RF 4 079 2480 FREQ CH.
DB-2400 Digital Belt-pack Transmitter Battery type setting 1 Press-release MENU button until the CHANNEL-BATTERY TYPE page appears.. CH :0 76 AKLN 2 Press and hold SET button until NIMH or AKLN flashes to denote readiness for setting. CH :0 76 AKLN 3 Press-release SET or MENU button to select either NiMH (rechargeable battery) or AKLN (alkaline battery). CH :0 76 NIMH 4 After a battery type is chosen, wait about 3 seconds to store the setting.
Instructions RF power setting 1 Press-release MENU button until the CHANNEL-RF POWER page appears. CH :0 76 RF08 2 Press and hold SET button until the RF power figure flashes to denote readiness for setting. CH :0 76 RF08 3 Press-release SET (UP) or MENU (DOWN) button to choose an output level from 0db to 20db. CH : 076 RF 12 4 After an output level is chosen, wait about 3 seconds to store the setting.
DB-2400 Digital Belt-pack Transmitter GAIN setting (GT|MT) Gain control enables the user to set different output levels. ▼ ▼ GT (LEFT) is for the use of instrument with high impedance, such as guitar. MT (RIGHT)is for the use of low impedance such as . lapel or headset microphones CHIAYO ELECTRONICS CO.,LTD. Http://www.chiayo.com.tw|Email: sales@chiayo.com.