User's Manual

ManualsBrandsChiayo Electronics ManualsElectronicsUHF Portable Transmitter

Table Of Contents

CT-711 / CR-711 / CT-800

OPERATION MANUAL

UHF PLL Beltpack Transmitter & Receiver / Stationary Transmitter

Printed in Taiwan, November 2009 12I1203

12I1203

CT-711 / CR-711 / CT-800

OPERATION MANUAL

UHF PLL Beltpack Transmitter & Receiver / Stationary Transmitter

Printed in Taiwan, November 2009

FCC Caution: To assure continued compliance, any changes or modifications not expressly

approved by the party responsible for compliance could void the user's authority to operate

this equipment. (Example - use only shielded interface cables when connecting to computer

or peripheral devices).

THIS DEVICE COMPLIES WITH PART 74 OF THE FCC RULES. This equipment complies

with FCC RF radiation exposure limits set forth an uncontrolled environment.

FCC ID:CINCT-711

Summary of content (6 pages)

PAGE 1
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). THIS DEVICE COMPLIES WITH PART 74 OF THE FCC RULES. This equipment complies with FCC RF radiation exposure limits set forth an uncontrolled environment.
PAGE 2
Introduction FCC Caution : Congratulations and thank you for the purchase of CT-711 / CR-711 / CT800 Tour Guide / Assistive Listening System. This system is PLLsynthesized with 100 factory preprogrammed channels. Please read this manual thoroughly to be fully familiarized with its controls and functions. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
PAGE 3
2.Fitness centre broadcast use. Charging the batteries First, make sure the types of the battery mode and batteries installed are all NiMH. Secondly, both batteries have to be of the same brand/ specification. When the battery-status LED keeps flashing, it means the batteries are weak and recharging is thus necessary. There are 2 methods of charging, namely via A: AC adaptor-Plug the connector of the adaptor into the DC IN jack of the transmitter and the adaptor to a wall AC outlet.
PAGE 4
Various setting display pages CT-800 Stationary Transmitter 6 UP button MENU button First, press the release buttons on both sides of the transmitter to open the battery compartment. Press SET once to make the display roll to CH: 001 725.000M This page shows the current channel and its corresponding frequency. You can press UP and DOWN to choose a desired channel. There are 100 preset channels for selection.
PAGE 5
CR-711 Parts and functions 1 2 3 To operate, press power ON button ( 8 ) once, then the CHANNEL / AF SIGNAL page will appear: CHANNEL:090 AF 4 Press MENU button once, the display will change to FREQUENCY / AF SIGNAL page : EC-16 (ear speaker) 722.
PAGE 6
Various setting display pages CT-711 Parts and functions First, press the release buttons on both sides of the transmitter to open the battery compartment. 1 2 3 4 Press SET once to make the display roll to CH: 001 725.000M This page shows the current channel and its corresponding frequency. You can press UP and DOWN to choose a desired channel. There are 100 preset channels for selection.