VT-M2M-C335L User Manual VT-M2M-C335L Chengdu Vantron Technology, Ltd. www.vantrontech.com.
VT-M2M-C335L Revision History: No. Version 1 V1.0 Description Initial Version Date 2022.06.
VT-M2M-C335L Table of Contents 1. Foreword ...................................................................................................................................4 1.1 Copyright Notice.........................................................................................................................4 1.2 Notes ..........................................................................................................................................4 1.3 Statement ...........................
VT-M2M-C335L 1. Foreword 1.1 Copyright Notice While all information contained herein have been carefully checked to assure its accuracy in technical details and printing, Vantron assumes no responsibility resulting from any error or features of this manual, or from improper uses of this manual or the software. Please contact our technical department for relevant operation solutions if there is any problem that cannot be solved according to this manual.
VT-M2M-C335L 1.5 Limitation of Liability/Non-warranty For direct or indirect damage to this device or other devices of Vantron caused by failure of conforming to this manual or the safety instructions on device label, Vantron assumes neither warranty nor legal liability even if the device is still under warranty. The VT-M2M-C335L should be installed, debugged and maintained by professional people. The outside antennas are not permitted to be installed or to be changed by non-professional people.
VT-M2M-C335L during transportation or placed under high temperature. Place cables properly: Do not place cables at any place with extrusion danger. Cleaning Instructions Please power off before cleaning the device. Do not use spray detergent. Clean with a damp cloth. Do not try cleaning exposed electronic components unless with a dust collector. Support for special fault: Power off and contact technical support personnel of Vantron in case of the following faults: The device is damaged.
VT-M2M-C335L 2. Overview 2.1 Introduction Thank you for choosing Vantron. It is our commitment to provide our valued customers with the embedded devices equipped with the state-of-the-art technology and the best product services. Vantron’s M2M products are based on the most advanced ARM and Intel Atom processors and have low-power consumption and high integration. The products are designed for applications of M2M in industrials, financial, retail, vehicle, and transportations etc.
VT-M2M-C335L 3. VT-M2M-C335L Hardware Instructions 3.
VT-M2M-C335L 3.2 Interface Description 3.2.1 Power Interface PIN1 Power connector outlook Pin Description 1 Power input range DC9-36V 2 DC Ground 3 Shell ground 3.2.2 Ethernet Interface Standard RJ45 interface, supporting 10M/100M Full/Half Duplex, this is a standard RJ45 Ethernet port 3.2.3 RS232 or RS485 Connector Standard vertical 1x3x3.81mm male Terminal Block. Pin 1 2 3 Description TXD1 or RS485_A RXD1 or RS485_B GND 3.2.4 RS485 Connector Standard vertical 1x3x3.81mm male Terminal Block.
VT-M2M-C335L Pin 1 2 3 Description RS485_A RS485_B GND Remarks IO IO 3.2.5 Boot Configuration Boot Configuration 000x: Boot from SD/MMC 111x: Boot from EMMC 3.2.6 LED PWR LED: lightindicatesystem power OK(main power up);offindicate system power turn off SS LED: User can define by themself. TX LED: when UART2 send data, TX1 can blink; when UART4 send data, TX2 can blink. RX LED: when UART2 receive data, RX1 can blink; when UART4 receive data, RX2 can blink. 3.2.7 DEBUG CONN, 3.
VT-M2M-C335L 3.2.9 SD/MMC and Micro SIM socket The support standard Micro SD card and Micro SIM socket.
VT-M2M-C335L 4. Tips Waste Disposal It is recommended to disassemble the device before abandoning it in conformity with local regulations. Please ensure that the abandoned batteries are disposed according to local regulations on waste disposal. Do not throw batteries into fire (explosive) or put in common waste canister. Products or product packages with the sign of “explosive” should not be disposed like household waste but delivered to specialized electrical ＆ electronic waste recycling/disposal center.
VT-M2M-C335L FCC compliance statement This device complies with part 15 of the FCC Rule. Operation is to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
VT-M2M-C335L Le présent appareil est conforme aux CNR d’ISDE Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
