NFC Reader Writer / Vetee Users manual Thank you for purchasing the "Vetee". Before using the product, please refer to this manual and make sure to use it correctly.
Table of contents For your Safety..................................................................................................................................................................6 1. Before Use ..................................................................................................................................................................10 ■ Components............................................................................................................................
Introduction Store this manual in a place where it can be found whenever needed. This manual explains basic function and operation. This manual does not explain the operational business. For business use, please refer to the "Application Manual". Attention ・This manual must not be reprinted in part or whole without permission. ・The manual contents may be changed at anytime without notification. ● Important Notes (1) This manual must not be reprinted in part or whole without consent.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Read This First [About the symbols] The symbols and the equipment illustration used in this manual are for safe use of the equipment, and to prevent any damage or harm to the customers and others. The symbols and their meanings are shown below. Read the manual after understanding the meanings of these symbols. Explanation of Symbols in This Manual Ignoring this display and incorrect handling may cause death or serious injury to a person.
For your Safety Away from Pacemaker Use the equipment at least 22cm away from Implantable Cardiac Pacemaker. Do Not Use in Prohibited Areas Do not use near a person who are using medical equipment such as cardiac pacemakers and hearing aids. Wave output from the equipment is much lower comparing to mobile phone. The effects on medical electric equipment are very low, but please follow the instructions in each Medical Institution when using.
For your Safety Keep Away from Fire Do not use the equipment near flammable gas and flammable material. It may cause fire or explosion. Do Not Touch with Wet Hands Do not replace the Battery Pack or turn the power on/off or plug/unplug the AC Adapter or Power Cable with wet hands. It may cause electrical shock. Regarding Disposal When disposing the product, do not incinerate or throw into fire. It may burn intensely and it is dangerous.
For your Safety Do Not Insert Water or Foreign Objects into the Equipment Do not insert liquid (such as water) or foreign objects (such as pins or paper clips) into the equipment. It may cause fire, electric shock or breakdown. When water or foreign objects are inserted, turn the power off and contact your retailer. Do not disassemble. Do Not Place the Equipment in Dusty/Humid Area Do not use this equipment in dusty or humid places (such as near water heater). It may cause fire.
For your Safety Reminder Safety Precautions ● Do Not Use the Equipment in a Place where the Temperature change is Extreme Temperature range of this product is 0 - 40 degrees (humidity 20 - 80% RH) with non-condense condition. Do not place this equipment where temperature is lower or higher than the range and where there is high humidity, etc. ● Do Not Drop or Apply shock The equipment is moveable and can endure normal vibration but be careful not to subject it to strong vibration and to shock by dropping.
1. Before Use ■ Components Refer to the check list below, and confirm that all the components are enclosed. □ Main Unit □ Users Manual (This book) Please contact the retailer if there are any components missing or damaged.
■ Name of Each Part and their Functions 4 Green LED : The green light indicates when read Contactless IC card. Reads contactless IC card by holding the card above it. This terminal has two types as below. USB2.0 Standard A plug USB2.
2. How to use ■How to Power On/Off. 1. Power On Please turn on a host's power supply after connecting a USB cable to a host. 2. Power Off Please turn off a host's power supply before disconnecting a USB cable to a host.
■ How to Use Contactless IC card reader. This terminal can be used with Contactless IC Cards and mobile phones equipped with the Contactless IC Card Function. ●Contactless IC Card Hold the card to match the center of the card with the center of the Contactless IC card reader. ●Take out the Contactless IC Card if it is in a wallet when using. ●The Contactless IC Card cannot be read when placed upright. ●Do not put the IC Card on the top of another IC Card when using.
3.Cleaning ■ How to Clean the Product Main Unit cleaning methods and important notes. ●Main Unit For a daily cleaning, use a soft, dry and clean cloth to wipe stains off. For stubborn stains, use a soft wet cloth, well squeezed, to wipe stains off. ●Do not wipe off with a volatility organic solvent (benzene, thinner, etc.).The use of such materials may cause deformation, discoloration, and breakdown to the equipment. ●Turn the power off before cleaning.
4.Troubleshooting If you experience any trouble, refer to the solutions below. Troubles The power does not turn on. Contactless IC Cards or mobile phones equipped with the Contactless IC Card Function cannot be read. Check point Check the USB cable connection.
5.Specification and Regulation Product code VRW-01A VRW-01B Remarks Host Interface USB2.0(StandardA) USB2.0(MicroB) Full speed Indicator 4 green LED Power Supply From USB Dimensions 116.6(W) x 130.7(D) x 17.4(H) mm Weight Around 149.
NFC Reader Writer / Vetee User’s Manual (basic section) 1st edition, published in Jun, 2012 NEC Corporation (81)3-3454-1111 (representative) Shiba 5-7-1, Minato-Ku, Tokyo Zip code: 108-0014 NEC Corporation 17