User manual

Safety Instructions
It is important to use your cooktop safely. Check these safety points before using your cooktop.
This appliance is not intended for use by young children or infirm persons without supervision.
Put ONLY cookware on the cooking area.
DO NOT cook directly on the ceramic surface as food will stick to the surface and will cause problems.
If the ceramic cooktop cracks,IMMEDIATELY switch off the cooktop at the power supply.
Keep anything which will melt away from the surface e.g. plastic, foil and sugar.
DO NOT touch the cooktop while it is still hot.
DO NOT stare at the Halogen Elements when cooking, ( fitted on selected models).
Operating Instructions
The Features of your cooktop
The heating elements are concealed under the smooth glass surface which has a pattern to show the location of the element.
The elements are controlled by energy regulators (see diagram opposite).
Using the elements
Choose the element you want to use.
Set the control knob to the high setting so boiling point is reached quickly.
Adjust the setting downwards until the desired heat setting is reached.
Dual circuit element
Some models have one element which has a dual circuit;
Circuit 1: allows the whole element rotate the control knob
to be heated to the right past halfway
Circuit 2: allows the central area rotate the control knob
only to be heated to the right up to halfway
saves energy when using
smaller pans or when
simmering gently
Warning Lights
are located in the front of the cooktop under the ceramic top.
show that the ceramic cooktop is still hot after the control is turned off.
stay on until the cooktop has cooled down to below 60
o
C.
Choosing and Using Pots and Pans
DO NOT operate an element without a cooking pot or pan on it.
Use pots and pans with flat heavy bases. Pots and pans with uneven or thin bases will take longer to cook.
DO NOT use pots or pans which overhang the elements more than 50mm. Oversized pots and pans can cause fine cracks
on the cooktop ( see diagram below).
Check the base of pots and pans are level with a ruler.
Check the bottoms of pots and pans are free from grit as this can scratch the ceramic surface.
Cook with lids on pots and pans as this will save time and electricity.
Always lift pots and pans from place to place on the ceramic surface.DO NOT slide the pots or pans as this may scratch the
surface.
DO NOT place steamy or wet utensils on the cooktop.
Using the Cooktop for the First Time
Before you use your cooktop for the first time, read these instructions carefully.
Switch the element on for 5 to 10 minutes. This will get rid of.
material left from the manufacturing process.
odours.
Some smoke may appear but this is normal and will soon disappear.
When the ceramic surface is cooled, clean it with a non-abrasive liquid ceramic cooktop cleaner e.g. Mica cooktop
cleaners and conditioners.
DO NOT use the cooktops as a work surface as this may scratch the surface.
DO NOT cut or chop food on the ceramic surface.
Cleaning Instructions
Clean the cooktop regularly while it is still warm with a suitable non-abrasive liquid ceramic cooktop cleaner.
Remove melted material IMMEDIATELY while the surface is still hot by:
using a razor blade scraper to remove material.
using a ceramic glass scraper.
rinsing and wiping dry with a clean cloth or paper towel.
DO NOT leave food on ceramic surface as cooktop may become stained.
DO NOT use abrasive or corrosive cleaners, scouring pads, steam cleaners, wire wool or oven cleaners.
Be careful not to scratch the surface with bracelets or rings.
Troubleshooting
If you call for a service and there is nothing wrong with your cooktop, you will have to pay for the service call. You will have to
pay even when the cooktop is under warranty. Before you call for service, check the points in these tables.
Problem Possible Causes
Elements do not operate Power supply is off
Power not turned on
Controls set incorrectly
Household fuse has blown - if fuse keeps blowing
then call the Service Centre
Low Heat,slow cooking
Incorrect cooking utensils being used
Information, Service and Parts
Service
If you need information, service or replacement parts you need to quote
The model number
The serial number
These numbers are on the data plate which is on the bottom of the switch panel cover.
If you need more information, please contact the Customer Care Centre
Australia New Zealand
On 1300 363 640 Or 09 573 2384
Open from 8.00 am till 5.00 pm Open from 8.00 am till 5.00 pm
Monday to Friday (Eastern Standard Time). Monday to Friday.

Summary of content (2 pages)