User Manual

ManualsBrandsCheckers Industrial Safety Products ManualsAccessories & SuppliesLinebacker CP5X125-GP-O/Y Polyurethane Heavy-Duty General-Purpose 5-Channel Cable Protector with T-Shaped Connectors, Orange Lid with Yellow Ramp, 36" Length x 17.25" Width x 1.95" Height

HEAVY DUTY

GENERAL PURPOSE

5 CHANNEL SYSTEM

ASSEMBLY:

• Inspect areas for safety hazards

• Assemble sections by aligning female connectors over male connectors

• Press with foot to secure female connectors to male connectors

• Open cover and install cables down into channels

• Close cover flush with base

• Test installation for intended use

• Periodically inspect installation

CHANNEL CAPACITY:

LOAD CAPACITY:

The Cable/Hose Protection System has different load supporting capabilities depending on type of vehicle and

temperature. Suitability must be verified by testing under actual conditions.

OPERATING TEMPERATURE:

-40

F to 120

F (-40

C to 48

CHEMICAL RESISTANCE:

Tested for compatibility with common motor oils, gasoline and diesel fuel.

Limited resistance to brake fluids and other chemicals.

MATERIAL:

UV-stabilized polyurethane elastomer

NO. OF

CHANNELS

5 Channel

10,500

lbs. (4,763 kg)

LOAD CAPACITY PER TIRE

MAX LOAD 70

F (21

21,000 lbs. (9,526 kg)

LOAD CAPACITY PER AXLE

MAX LOAD 70

F (21

CABLE/HOSE MANAGEMENT COMPONENTS

ASSEMBLY INSTRUCTIONS

#ZIS-GP5

Ver: 2/11

CHANNEL CAPACITY - MAX. DIAMETER INCHES (mm)

1 Channel 1.3 in. (33 mm) width x 1.3 in. (33 mm) height

Simply interlock with

T-connectors to extend

protection length.

36" Lineal ProtectorEnd Cap End Cap Y Protector

GP-5

Summary of content (2 pages)

PAGE 1
GP-5 HEAVY DUTY GENERAL PURPOSE 5 CHANNEL SYSTEM ASSEMBLY INSTRUCTIONS ASSEMBLY: • • • • • • • Inspect areas for safety hazards Assemble sections by aligning female connectors over male connectors Press with foot to secure female connectors to male connectors Open cover and install cables down into channels Close cover flush with base Test installation for intended use Periodically inspect installation Simply interlock with T-connectors to extend protection length.
PAGE 2
GP-5 HEAVY DUTY GENERAL PURPOSE 5 CHANNEL SYSTEM CABLE AND HOSE MANAGEMENT SYSTEM INSTALLATION INSTRUCTIONS LINEBACKER® GP-5 is a cable/hose management system intended to reduce the possibility of damage to cables and hose lines that are subject to pedestrian and vehicular traffic. It is intended for temporary installations only and must be in accordance with all applicable electrical, building and safety codes. DO NOT use connectors or splices within this system.