TFX-125BL Shadow™ 125 USER MANUAL Chauvet, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.
TABLE OF CONTENT TABLE OF CONTENT........................................................................................................................................................... 2 BEFORE YOU BEGIN........................................................................................................................................................... 3 WHAT IS INCLUDED ..................................................................................................................................
BEFORE YOU BEGIN What is included ¾ ¾ ¾ ¾ TFX-125BL fixture H-125BL Blacklight bulb Power cord with plug Warranty Card & Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling.
INTRODUCTION Features • • • • • • high-powered 125-watt blacklight cannon long throw easy lamp access safety wire mesh switch-selectable power settings 115V or 230V, (240V available) no duty cycle! Product Overview Hanging bracket Tension knob Lamp wire mesh cover Product Overview TFX-125BL User Manual 4 Revision: 2004-11-02/11:32
SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A bulb is included with your product. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
Setup Mounting ORIENTATION This fixture may be mounted in any position provided there is adequate room for ventilation. R IG G IN G Figure 3 - Clamp Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs. • When selecting installation location, take into consideration lamp replacement access and routine maintenance. • Safety cables should always be used.
APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power.
Appendix General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controller s Dimmer s& Chaser Auto shut off Check fan thermal switch reset 9 Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting 9 Breaker/Fuse keeps blowing Check total load placed on device Chase is too slow Check users manual for speed adjustment 9 9 9 Device has no power Check for power on Mains. Check device’s fuse.
Appendix Technical Specifications WEIGHT & DIMENSIONS Length............................................................................................................................. 216 mm (8.5 in) Width ............................................................................................................................... 254 mm (10 in) Height .............................................................................................................................. 254 mm (10 in) Weight ....